Sharp SW-100T Instruction Manual page 30

9. Make sure the sawing area is clear of any objects.
Start the blade and check the blade rotation. If the
electrical connections are made correctly, the blade
should run in a counterclockwise direction. If not,
shut the hydraulics off, turn off the machine as well as
the shop circuit breaker. Then swap the power the
power cable conductors connected to R and T
terminals.
10. Repeat step 6 to 9 to ensure the electrical
connections are in the right order.
Leveling
Place spirit level on the vise slide plates and the work
feed table.
Level the machine in both directions i.e. along and
across the machine. Adjust the level of the machine by
turning the leveling bolts.
Make sure all leveling bolts evenly support the
machine weight.
Anchoring the machine
Normally there is no need to anchor the machine. If the machine is likely to vibrate, fix the machine to
the floor with anchor bolts.
Shock absorption steel plates are provided and can be placed under each leveling bolt to prevent their
sinking into the concrete floor.