Erasing Diagnostic Trouble Codes (Dtcs) - Innova 3160g Owner's Manual

The Scan Tool will display a code
only if codes are present in the
vehicle's computer memory. If no
codes are present, a "No SRS DTC's
are presently stored in the vehicle's
computer" is displayed. Press the
SYSTEM MENU
to the System Menu.
3. If more than one code was retrieved press the DTC/FF button, as
necessary, to display additional codes one at a time.
Whenever the Scroll function is used to view additional codes,
the Scan Tool's communication link with the vehicle's computer
disconnects.
POWER/LINK
4. When the last retrieved DTC has been displayed and the DTC/FF
button is pressed, the Scan Tool returns to the "Priority" code.
To exit the enhanced mode, press the SYSTEM MENU
button to return to the System Menu. Use the UP
DOWN
press the ENTER

ERASING DIAGNOSTIC TROUBLE CODES (DTCs)

When the Scan Tool's ERASE function is used to erase DTCs
from the vehicle's on-board computer, "Freeze Frame" data
and manufacturer-specific-enhanced data are also erased.
"Permanent" DTCs ARE NOT erased by the ERASE function.
If you plan to take the vehicle to a Service Center for repair, DO NOT
erase the codes from the vehicle's computer. If the codes are erased,
valuable information that might help the technician troubleshoot the
problem will also be erased.
Erase DTCs from the computer's memory as follows:
When DTCs are erased from the vehicle's computer memory, the
I/M Readiness Monitor Status program resets the status of all
Monitors to a not run "flashing" condition. To set all of the Monitors
to a DONE status, an OBD2 Drive Cycle must be performed.
Refer to your vehicle's service manual for information on how to
perform an OBD2 Drive Cycle for the vehicle under test.
1. If not connected already, connect the
Scan Tool to the vehicle's DLC, and
turn the ignition "On." (If the Scan Tool
is already connected and linked to the
vehicle's computer, proceed directly to
step 3. If not, continue to step 2.)
2. Perform the Code Retrieval procedure
as described on page 33.
3160g
ERASING DIAGNOSTIC TROUBLE CODES (DTCs)
button to return
To re-establish
button again.
buttons, as necessary, to highlight Global OBD, then
button to return to the Global OBD2 mode.
Using the Scan Tool
communication, press the
and
65