Spring Bolt; Non-Spindled Technolgy; Slide Bolt; Lock Operating Conventions - Kaba Mas AUDITCON 100 series Operating Instructions Manual

Spring Bolt - The dial must be turned to the right to retract the bolt
and then must be held until the container is opened so that the bolt
does not "spring" back into place. Automatic locking of the lock
occurs as soon as the container door is closed. The lock dial does
not have to be turned to the left to extend the bolt.
Non-Spindled Technology:
The "Home" position on the Non-Spindled version of the lock does not
exist since without a spindle there is no relation to the turning of the
spindle and retraction or extension of the bolt.
There is only one bolt available at this time on the Non-Spindled
version of the lock.
Slide Bolt - Once a combination has been entered and accepted
for access to the lock, the bolt movement works in conjunction with
the boltworks of the container. When the boltworks are disengaged
to open the container, the bolt will be forced into the "unlocked" or
retracted position. Once the boltworks are extended to the locked
position, the lock bolt automatically extends into the "locked"
position. There is no spindle involved, so the lock dial itself does
not have to be turned to retract and extend the lock bolt.
Note: The lock will "relock" if the boltworks are not engaged within 6-8
seconds after the combination is accepted.
See the section of the manual on Optional Features for more detail.

Lock Operating Conventions

The following conventions apply to lock operations:
• To clear a combination or keystroke, press the Clear key.
• To initiate a lock operation other than opening the lock, you must press
the Enter key or the Enter key twice followed by the number associ-
ated with that lock operation (e.g., when adding a User you would
press Enter and then 3).
• After initiating a lock operation, if 40 seconds expire without input to the
keypad, the lock resets requiring you to re-key the entire operation.
17