Atec ROD-L M25 Operation And Service Manual page 12

TABLE 2-1 CONTROLS AND INDICATORS (continued)
FIG. 2-2
INDEX NO CONTROL FUNCTION
Ohms Meter (RMeter)
T o t a l C u r r e n t Meter
( I METER)
FAIL Indicator (14)
TESTING Indicator (I 3)
READY Indicator (I 2)
Audible Warning (SP1)
AC Line Voltage (A71
AC Line power r e c e p t a b l e (J1)
Line Fuse (F2)
Line Supply Fuse ( E l )
Ohms T r i p P o t (R5)
Low Line Switch (S5)
Serial/Model Code Label
R e m o t e Control Connector(J3)
Hipot I n t e r f a c e Connector (54)
2-6
Provides
a
d i r e c t reading of
t h e Resistance of
t h e
t e s t e d
instruments ground loop.
Indicates amount of AC
c u r r e n t in (AMPS) flow
during a test.
Displays a visual warning
t h a t test was a failure.
Indicates a test in progress.
Comes on a power up.
E m i t s
a
warning sound
when a t e s t r e s u l t s in
a failure.
Slide switch t o s e l e c t
e i t h e r 1 1 5 VAC o r 230 VAC.
T h e exposed number
indicates t h e Line Voltage
r a n g e selected.
Connects t o power cable
supplied with instrument.
Provide primary circuit
protection f r o m over-
c u r r e n t conditions.
SAME AS ABOVE
C a l i b r a t e s Ohms Trip setting.
Compensate f o r input Low
Line Voltage condition-
normal,
-8%,
a n d -16%.
Identifies Serial Number and
Model number of
tester.
Allows R e m o t e signal
input and output.
Allows i n t e r f a c e with ROD-L
~ i i ' p o t tester.