CONGRATULATIONS CONTENTS Dear customer, General warnings ��������������������������������������������������������������������������3 Product description �����������������������������������������������������������������������4 Congratulations and thank you for choosing our appliance� Gas specifications ��������������������������������������������������������������������������6 We are sure you will find it a pleasure to use� Before you use the appliance, we recommend that you read through the Gas connection detail ��������������������������������������������������������������������6 relevant sections of this manual, which provide a description Natural gas installation�����������������������������������������������������������������7...
IMPORTANT SAFETY INSTRUCTIONS Please read the user manual carefully and store in a handy place for later reference� WARNING WARNING • Do not lean over appliance when lighting. TIPS & INFORMATION IMPORTANT • Do not leave the appliance unattended when alight. Important –...
GAS SPECIFICATIONS NATURAL GAS TYPE UNIVERSAL LPG Maximum gas 22 MJ/h 23 MJ/h consumption Injector office 2�30mm 1�30mm diameter Number of injectors Regulator 1�00 kPa 2�75 kPa pressure NOTES: • This appliance MUST be installed and serviced only by a qualified licensed person� •...
NATURAL GAS INSTALLATION LEAK TEST PROCEDURE This appliance is supplied set up for Natural gas and is • Ensure gas valve is in the ‘OFF’ position� labelled accordingly� A Universal LPG conversion kit is • In a small container, mix a solution of water and detergent or supplied if required�...
UNIVERSAL LPG INSTALLATION NOTE: Conversion of this unit to Universal LPG must be 2� Remove two screws fastening burner� carried out by a qualified licensed person and a Certificate of Compliance must be issued to the owner on completion of Screw the installation and conversion�...
UNIVERSAL LPG INSTALLATION GAS BOTTLE SAFETY 5� The factory setting for the primary air shutter is fully Gas bottle safety information open, and should not be modified� Ensure the primary • This appliance is designed to use a 9kg (20 lbs) air shutter is fully open before replacing the burner�...
2�75kPa� • This appliance must not be installed or used inside an BeefEater strongly recommends installation of a manual inadequately ventilated building� Building ventilation shut-off valve, or hose assembly with a certified quick must comply with Clause 5�13 of AS/NZS 5601�1� This...
INSTALLATION INSTRUCTIONS Installation warnings When planning the location and preparing the installation The mounting enclosure structure for this appliance note the following: • The appliance requires a non-combustible barrier under • This appliance is Certified to AS 4563, and Clause 6�10�2 the appliance to prevent excessive temperatures being of AS/NZS 5601�1 is applicable�...
INSTALLATION INSTRUCTIONS DIMENSIONS Side view - lid up 71mm min� From cutout Side view - lid down Bench width 600mm min� Vent 250mm x 25mm (required 540mm when installed separately to barbecue) WARNING! • This appliance requires venting� This vent is to allow air into the enclosure for the correct combustion of gases and for the correct exhausting of the products of combustion�...
GAS REQUIREMENTS POSITIONING OF BURNER Installation warnings Natural Gas requirements • The enclosure must be constructed so that access can be gained to the Natural Gas regulator at all times� • For pipe sizing requirements for supply pipe refer to AS/NZS 5601�1� Universal LPG requirements •...
CONNECTING TO THE INTEGRATED BARBECUE If the integrated burner is located adjacent to the built in barbecue and the units are to be connected to the same outlet or cylinder, the gas line must branch off prior to the regulator� Each appliance must have its own regulator� For Natural Gas This can be achieved with hard plumbing to each of the regulators�...
BURNER OPERATION PIVOTING SAFETY LEG Installation warnings Control functions To ensure that the user remembers to turn off the gas before closing the lid, a pivoting safety leg has been fitted� Before lighting the burner: • Check that all hoses and gas fittings are tight� •...
CLEANING AND CARE The Beefeater integrated burner has been constructed from Burner select grade stainless steel which, if not cared for, may The burner ports should be checked for blockages and discolour over time� To keep your appliance looking its best cleared as required�...
Ignition electrode wet not working or dirty cast iron reversible grill plate Manually light the weatherproof cover burner (for model BSW318SA) Flame not Knob not Repeat lighting + Standard inclusion with the product but can also be purchased staying on held down procedure and hold separately via the Electrolux Customer Service Centre�...
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: BEEFEATER SIGNATURE BARBECUE 7. You may not make a claim under this warranty unless the defect claimed is This document sets out the terms and conditions of the product due to faulty or defective parts or workmanship. Electrolux is not liable in the warranties for Electrolux Appliances.
Page 20
For more information on all Beefeater products, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 307 939 fax: 1800 356 669 email: customercare@electrolux.com.au web: beefeaterbbq.com...
Need help?
Do you have a question about the BSW318SA and is the answer not in the manual?
Questions and answers