Changing The Volume And Sound; Switching The Broadcast Audio Channel - Pioneer Kuro PDP-LX609A Operating Instructions Manual

Watching TV
Note
• Pressing EXIT, RETURN, or TOOLS again causes the TOOLS Menu to
disappear.
• If the number of channels registered reaches the limit, a warning screen
appears.
• To cancel the above procedure before it finishes, press EXIT or RETURN.
• Home Media Gallery is unavailable for PDP-C509A.
Editing Input List
You can edit the input channel name. For changing the name, follow the
procedure below.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "Option" (/ then ENTER).
4 Select "Label Input" (/ then ENTER).
5 Select an input (/ then ENTER).
The software keyboard appears.
6 Edit the name.
7 Press HOME MENU again to exit the menu.

Changing the volume and sound

Use the remote control or the control panel on the left-hand side of the flat screen
TV to adjust the volume.
Using i +/i – on the remote control unit
• Press i + to increase the volume.
• Press i – to decrease the volume.
• VOLUME +/– on the flat screen TV operates the same as i +/i –.
Using e on the remote control unit
Press e to mute the sound.
1
e appears on the screen. If headphones are used,
2 Press e again or i + to restore the sound.

Switching the broadcast audio channel

Depending on the broadcast, you can switch the audio channel.
Press - to change the audio channel.
•
• Pressing TOOLS also causes the audio channel mode menu to appear.
The table below shows the available audio channels by broadcast audio type.
Stereo
Bilingual
Monaural
37
DualMono
Stereo
appears.
37
Monaural
37
• In each of the sound multiplex mode selected using the - button, the
display changes depending on broadcasting signals being received.
• Once the MONO mode is selected, the sound remains mono even if the
system receives a stereo broadcast. You must switch the mode back to  or 
mode if you want to hear stereo sound again.
• Selecting a sound multiplex mode while the input source is "INPUT 1" to
"INPUT 6" does not change the type of sound. In this case, sound is
determined by the video source.
mode mode
I II
Note
Setting

A 1
DDD DDD
STEREO STEREO
10:00 10:00
A 2
EEE EEE
DUAL I DUAL II
10:00 10:00
A 3
FFF
MONO MONO
10:00 10:00
D 001 D 001
GGG GGG
L
10:00 10:00
D 002 D 002
HHH HHH
STEREO STEREO
10:00 10:00
D 003 D 003
III
MONO MONO
10:00 10:00
Note
MONO mode
MONO

MONO
A 1 A 1
DDD
MONO
10:00
A 2 A 2
EEE
MONO
10:00
A 3 A 3
FFF FFF
MONO
10:00
D 001
GGG
R MONO
10:00
D 002
HHH
MONO
10:00
D 003
III III
MONO
10:00
06
21
En