GE Hygromaster Instruction Manual page 17

Enter the required logging parameters as follows:
7.
Be sure to enter the Logging Interval, Wait Before First Log, Number of Logs and Job
Note:
No in the appropriate boxes.
Press "Set Interval" button to send to the instrument.
a.
Confirm that the logging parameters are set correctly by pressing the "Check Interval"
b.
button, and ensure that the settings you require have appeared in the appropriate
parameter boxes.
Finally, check that the 'logging' icon
c.
It does not matter whether the above is set from the PC or in "Logging Setup" mode, as
Note:
described in Logging Set-up Function (Table 6).
Remove the RS232 serial cable from the instrument port and place it in the environment that
8.
is to be monitored. Ensure that a Hygrostick or Quikstick sensor is plugged into the top of
the instrument.
Press and hold
9.
GE Protimeter Hygromaster
until the display shows OFF.
is lit on the instrument display.
Page 17