Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Invisible systems ISL067R
Summary of Contents for Invisible systems ISL067R
- Page 1 Wireless RF ISL067R Transceiver User’s Guide This document contains information about the hardware interface between ISL067 transceiver and Receiver. Information includes the theory of operation, specifications, interface definitions, configuration information and mechanical drawings...
- Page 2 Proprietary Material The information and descriptions contained herein are the property of ISL. Such information and descriptions may not be copied or reproduced by any means, or disseminated or distributed without the express prior written permission of ISL. This document is for information purposes only and is subject to change without notice. Statement of Limited Warranty ISL warrants equipment of its manufacture, and bearing its identification to be free from defects in workmanship and material for a period of 12 months for electronics and 12 months for mechanical...
- Page 3 Revision History Issue Date Author Comments 02/05/14 C Boddy Initial Release 15/05/14 V Tambe Added FCC statement P6 Operation is subject to the following two conditions: this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.
-
Page 4: Table Of Contents
Contents Safety Information ............................5 DECLARATION OF CONFORMITY ........................9 ISL067................................10 Theory of operation ............................10 3.1 Network Topologies ........................... 10 3.2 Point-To-Point ............................ 10 3.3 Point-to -Multipoint ..........................11 3.4 Other network topologies ........................12 Board Level Pin Assignments ........................14 Specifications .............................. -
Page 5: Safety Information
Industry Canada Approved Antenna List This radio transmitter ISL067R has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. - Page 6 FCC REQUIREMENTS NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment generates, uses, and can radiate radio frequency energy.
- Page 7 End Product Labeling The ISL067R Module is labeled with its own IC Certification Number. If the IC Certification Number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
- Page 8 Replacing battery !CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS WARNING! Only qualified service personnel may install this equipment. The instructions in this manual are intended for use by qualified service personnel only. Only qualified persons should service the system.
-
Page 9: Declaration Of Conformity
DECLARATION OF CONFORMITY Measurement Standard Applied ANSI C63.10:2009 Manufacturer: Invisible Systems Ltd 9 Beetham Rd Milnthorpe Cumbria LA7 7QL Product Description 925.78MHz Transceiver designed for low cost solution for wireless application Product Model ISL067 Part Number ?????? Test Laboratories Unit E... -
Page 10: Isl067
The ISL067R transceiver is a narrowband radio designed for license-free operation in 900MHz ISM band. The ISL067R has a fixed 1mW of output power for use in the USA and Canada 902MHz – 928MHz ISM bands. This is a full-duplex wireless data transceiver which is integrated with an ultra speed MCU and a powerful RF chip. -
Page 11: Point-To -Multipoint
3.3 Point-to -Multipoint Point-to-multipoint systems have one base station (receiver) that controls all communications with all of the other wireless nodes in the network. This allows for the creation of a wireless network consisting of multiple nodes. In a point-to-multipoint network the receiver would typically be set up as the access point and would be configured to receive data. -
Page 12: Other Network Topologies
This example of a repeater network would still be useful for a point-to-multipoint network where some of the transmitters are not in range of the primary access point. In this network topology an ISL067R product is setup as a repeater to act as the primary access point. - Page 13 Limitations: There are some limitations to this setup. • The addition of the repeaters requires additional radios which increases the cost of the systems. • The repeater setup must be powered by the supplied 12v main adapter. • The antennas of the transmitter and the receiver in the repeater should be positioned to minimize interference.
-
Page 14: Board Level Pin Assignments
4. Board Level Pin Assignments 1 2 3 4 5 6 7 Pins: 1-7 Pin Signal Assignment Color Ground Ground 3 Output VSW switched VDD out 4 Input 1 wire Data 5 Input Pulse Input 2 6 Input Analogue Input - 7 Input Analogue Input + 8 Output TX Out... -
Page 15: Specifications
Appendix 5. Specifications TABLE 1: ISL067R DETAILED SPECIFICATIONS INTERFACES Internal PCB antenna or UFL to SMA RF Connector Reverse Polarity Female Jack OPERATIONAL Network Topologies Point-to-Point, Point-to-Multi Point Security 925.78MHz Frequency Band 2400 kbps RF Data rate RF Technology Narrowband...
Need help?
Do you have a question about the ISL067R and is the answer not in the manual?
Questions and answers