Wiring - Kicker 1350 Installation Instructions

(Mounting, continued)
w/Grommets
To Speak
Front Dash
$ y--;z
3
_.I
To Crossover
Kick Panel
Similar caubons must be observed when mountrng speakers through the package tray
of a car. Watch for trunk springs, hrnges, and folding seat mechanrsms. When running the
wires be careful not to crush them with seat bolts or door sill screws.
Wiring
Hooking up the supplied wares to your IMPULSE driver
IS
very straightforward. The wlres
come with different size ends that will only plug on one way. The larger connector
IS
crimped on the gray wire and connects to the positive terminal of the speaker. The other
end of these wires connects to your source in a similar manner. The gray wire connects to
the positive output of the amplifier or radio. The black wire connects to the negative out-
put of the amplifier or radio. These connections can be made with crimp-on connectors or
solder and good electrical tape.
Speaker
Ouaut Source
output
Other
Channel
If you have more questions about the installation of Your KICKER component, see
the Authorized KICKER Dealer where you made your purchase. You may also call our
Technical Services Line at (405)624-8583 or contact us via the Technical Services
page on www.kicker.com.