Configuring Parameters For Mld Messages; Configuration Prerequisites; Configuring Source Ipv6 Addresses For Mld Messages - HP FlexFabric 5700 Series Configuration Manual

You can configure parameters for MLD queries and responses for the current VLAN in VLAN view or
globally for all VLANs in MLD-snooping view. The configuration made in VLAN view takes priority over
the configuration made in MLD-snooping view.
Configuring parameters for MLD queries and responses globally
Step
1. Enter system view.
Enter MLD-snooping view.
2.
3. Set the maximum response
time for MLD general queries.
4. Set the MLD last listener query
interval.
Configuring parameters for MLD queries and responses in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the MLD general query
interval for the VLAN.
4. Set the maximum response
time for MLD general queries
in the VLAN.
5. Set the MLD last listener query
interval in the VLAN.

Configuring parameters for MLD messages

This section describes how to configure parameters for MLD messages.

Configuration prerequisites

Before you configure parameters for MLD messages in a VLAN, complete the following tasks:
Enable MLD snooping for the VLAN.
•
Determine the source IPv6 address of MLD general queries.
•
Determine the source IPv6 address of MLD multicast-address-specific queries.
•
Determine the source IPv6 address of MLD reports.
•
Determine the source IPv6 address of MLD done messages.
•
• Determine the 802.1p priority of MLD messages.

Configuring source IPv6 addresses for MLD messages

You can change the source IPv6 address of MLD queries sent by an MLD snooping querier. This
configuration might affect MLD querier election within the subnet.
Command
system-view
mld-snooping
max-response-time interval
last-listener-query-interval interval
Command
system-view
vlan vlan-id
mld-snooping query-interval
interval
mld-snooping max-response-time
interval
mld-snooping
last-listener-query-interval interval
71
Remarks
N/A
N/A
The default setting is 10 seconds.
The default setting is 1 second.
Remarks
N/A
N/A
The default setting is 125 seconds.
The default setting is 10 seconds.
The default setting is 1 second.