Lfo Page - Elektron Digitone User Manual

Master of the digital method
Hide thumbs Also See for Digitone:
Table of Contents

Advertisement

12.5.1 SEL1-SEL8
CC 1–8 Select specifies the CC commands whose values you control controlled by the parameters on
the AMP PAGE 1 (CC VALUE) page. The selectable commands are the standard MIDI Control Change
Messages. (0–119)

12.6 LFO PAGE

The Low-Frequency Oscillator can be used to interact with the parameters found on the MIDI tracks' SYN1,
and FLTR pages. Customize the low-frequency oscillator behavior, orientation, and depth on this page.
Press [LFO] to access this parameter page.
12.6.1 SPD
Speed sets the speed of the LFO. Try settings of 8, 16 or 32 to sync the LFO to straight beats. The knob
is bi-polar. The LFO cycle can be played backward by using negative values. (-64.00–63.00)
12.6.2 MULT
Multiplier multiplies the SPD parameter by the set factor either by multiplying the current tempo (BPM
settings) or by multiplying a fixed tempo of 120 BPM.
12.6.3 FADE
Fade In/Out makes it possible to fade in or out the LFO modulation. The knob is bipolar. Positive
values give a fade out. Negative values give a fade in. 0 gives no fade in/fade out. (-64–63)
12.6.4 DEST
Destination selects the modulation destination for the LFO. Preview how the LFO modulation affects the
sound by highlighting a destination. Press [YES] to confirm the selection.
12.6.5 WAVE
Waveform sets the LFO waveform. There are seven waveforms: Triangle, Sine, Square, Sawtooth, Expo-
nential, Ramp, and Random.
12.6.6 SPH
Start Phase sets the point within the wave cycle where the LFO starts when it is trigged. 0 makes the
LFO start at the beginning of a complete wave cycle, 64 makes it start at the center. (0–127)
12.6.7 MODE
Trig Mode sets how the LFO acts when a note is trigged.
FRE is the default free-running mode. It makes the LFO run continuously. It will not restart or stop
even if it is trigged by a note.
TRG makes the LFO restart when a note trigs it.
HLD makes the LFO run free in the background, but when a note is trigged the LFO output level is
latched and held still until the next note is trigged.
12. MIDI TRACK PARAMETERS
51

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Digitone and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF