Quick Start - Minelab EQUINOX 600 Instruction Manual

Contents

Quick Start

EQUINOX is so easy to use, even a beginner can successfully begin detecting right out of
the box! There are just 4 easy steps to get started.
Before first use, it is recommended that you fully charge the battery for 4 hours (page 8).
Turn On
Press the Power button on the side of the control panel.
Select a Detect Mode
Select the optimum Detect Mode Search Profile for your detecting location.
(EQUINOX 800 shown).
'Detect Modes' on page 22
See
most suitable Detect Mode.
Noise Cancel
Select Noise Cancel from the Settings Menu, then press
Auto Noise Cancel. This will take approximately 8 seconds to complete.
Begin Detecting!
Press
for more information on how to choose the
to return to the Detect Screen, and begin detecting!
to initiate an
If excessive ground noise is heard
after performing the Quick Start
steps, carry out the Ground Balance
procedure (page 40).
If excessive noise is still being experienced
try adjusting the Sensitivity to a lower
level to reduce noise (page 34).
Quick Start | 11