Rio3224-D2/Rio1608-D2 (V1.10 Or Later); About Alerts (R Series) - Yamaha CL5 Supplementary Manual

Rio3224-D2/Rio1608-D2 (V1.10 or later)

Firmware V1.10 or later is required for Rio3224-D2/Rio1608-D2 to enroll a domain with DDM.
INFORMATION – REPORT screen
 Enrolling a domain
* Local Access = Read Only, Remote Access = None
 No DDM server
1
DDM_CONNECT_STATE
Displays the connection status to the DDM server in the network.
• CONNECTED: The unit has been connected to the DDM server in the network.
• DISCONNECTED: There is no DDM server in the network.
2
DDM_DOMAIN_KIND
Displays the enrolling status for the DDM domain.
• DOMAIN: DDM domain is enrolled
• UNMANAGED: DDM domain is not enrolled
3
DDM_DOMAIN_UUID
Displays the UUID of an applicable domain when enrolling the DDM domain.
When the unit has not enrolled a domain, FF–FF–FF–FF–FF–FF–FF–FF–FF–FF–FF–FF–FF–
FF–FF–FF is displayed.
4
DDM_LOCAL_ACCESS
Displays the accessing status of the Dante setup (including the DANTE PATCH settings)
of the unit.
• READ_WRITE: Editing is available
• READ_ONLY: Editing is disabled
5
DDM_REMOTE_ACCESS
Displays the status of Dante setup accessing the external Dante device.
• OPERATOR: Editing is available
(however, operating from the Rio3224-D2/Rio1608-D2 unit is not
available)
• GUEST: Reading is available, editing is disabled
• NONE: Reading and editing are disabled
INFORMATION – DANTE screen
 When enrolling a domain:
The DDM indicator appears at the top of right side of the DANTE screen.
The R/W indicator or the R/O indicator also appears, depending on the LOCAL CONTROLLER
ACCESS setting for the DDM server.
* LOCAL CONTROLLER ACCESS = Read Write
* LOCAL CONTROLLER ACCESS = Read Only
When the local access is set to "Read Only," changing the DANTE settings (UNIT ID,
SECONDARY PORT) on the Rio3224-D2/Rio1608-D2 unit will result in the following pop-up
message.
When a DDM domain is enrolled, unregistering the domain will result in the DISC indicator
appearing at the top right side of the screen. In addition, when a DDM domain is enrolled
without connecting to the DDM server, the DISC indicator also appears.

About Alerts (R series)

In the R series, excepting for the Rio3224-D2/Rio1608-D2 (Rio3224-D, Rio1608-D, Ri8-D,
Ro8-D and RSio64-D), when the LOCAL CONTROLLER ACCESS setting for the DDM server
is set to Read Only, if the settings of the DIP switches or the rotary switch are different from
the Dante settings, both the green and red SYSTEM indicators will light. In this case, set the
LOCAL CONTROLLER ACCESS for the DDM server to "Read Write."
5
Support for Dante Domain Manager
V4.5 Supplementary Manual