Using The Coffee Brewer - Bonavita BV1901TS Instruction

USING THE COFFEE BREWER

1. Remove the thermal carafe and slide the filter basket out of the brewer.
2. Raise the lid of the water tank and pour 4-8 cups of fresh cold water into
the tank (Fig. 1). Do not fill above the MAX fill line.
3. Place a basket style filter in filter basket. We recommend a basket filter with
a 3 1/4" base dimension. Scoop ground coffee into the filter. We recommend
two level tbsp. of drip grind coffee per cup, varying the amount according
to your taste (Fig. 2). This equates to approximately 7 to 9 grams of coffee
per cup.
4. Slide the filter basket back into the holder until it snaps into place and the
indicator on the filter basket handle is fully covered. (Fig. 3).
5. Place the carafe with the lid removed under the filter basket. Switch the
appliance on. The on/off switch will light up to show that the machine is
operating (Fig. 4).
6. After the brewing process ends, a beep will be heard once the cycle is
complete, remove the coffee-filled carafe from the appliance. To dispose of
the used filter and coffee grounds, we recommend dumping it from the filter
basket. Rinse the filter basket out, and set aside to dry.
7. To pour and for maximum heat retention, place the lid on the carafe shortly
after the brew cycle is complete. (Fig. 5).
8. For pouring coffee from the thermal carafe, depress the lever on carafe's lid.
The lid must be tightened firmly to allow for one-handed pouring (Fig. 6).
9. The appliance is equipped with an automatic shut off function which triggers
when the brew cycle is complete. The appliance can be switched off manually
at any time by using the on/off switch.
Optional: Freshly roasted coffee has more CO
brewing with freshly roasted coffee, or you would like to pre-infuse the coffee,
press and hold the power switch for 5 seconds. At that point the power switch
light will flash and 2 beeps will be heard indicating that you've enabled the
pre-infusion mode. Press and release the power switch a second time to begin
brewing. You can disable the pre-infusion mode by pressing the power switch
until the light blinks (5 sec.) and a single beep is heard. The brewer will remain in
this mode until the mode is turned off or the brewer is unplugged.
trapped in the bean. If you are
2
7