G70 - Finishing Cycle - Hurco WINMAX Programming Manual

G70 - Finishing Cycle

G70 causes the tool to make a finish pass along the profile. Individual feeds and speeds
are used in the profile. Remaining roughing stock is removed.
Modal—No
F, S, and T functions specified in Profile blocks using G71 - Stock Removal in Turning, G72
- Stock Removal in Facing, and G73 - Pattern Repeating are ignored until a G70 is active.
Format
G70 P ____ Q ____ F ____ S ____ T ____
Parameters
• P—first sequence number of Profile
• Q—last sequence number of Profile
• F—cutting feedrate
• S—spindle speed
• T—tool
2 - 46 ISNC G Codes
v546NC
WinMax Lathe NC Programming