PEmicro Cyclone MAX User Manual page 84

CYCLONE MAX
11.2.6 Hex Lower Bounds
There is one display column for each byte of the lower bound of the serial
number in hex.
11.2.7 NEW
Instructs the program to start editing a NEW (as yet un-named) serial number
file. It will throw away the information for any serial number currently being
edited unless that information has been saved (Save Button). The new serial
number is initialized with one (1) byte of binary.
11.2.8 SAVE
Instructs the program to save the current serial number being edited into the
file name and path shown in the Serial Number File window. If a file name has
not been provided, i.e. the window shows None Selected, then an error is
displayed in a red window on the screen. If this happens, type in a filename in
the window and click Save again.
11.2.9 HELP
Opens the Serialize help system (serialize.hlp file, i.e. this file) for perusal.
11.2.10 QUIT
Turns off the Serialize Program and saves any setup information in the file
Serialize.ini. This file will initialize the setup information the next time the
program is started. Xing out of the program (top right of screen) does not save
the setup info.
11.2.11 BINARY, NUMERIC, CONSTANT, ALPHA UPPER, ALPHA LOWER, and
78
• Double Click on Hex - Selects or deselects the byte column. Selected
shown in yellow. The serial number byte in this column may then be
modified using the buttons at the bottom of the Serialize utility. Please
refer to Section 11.2.11 - BINARY, NUMERIC, CONSTANT, ALPHA
UPPER, ALPHA LOWER, and PRINTABLE.
• Up Arrow Click - Increases the lower bound by one with a maximum
of the current serial number byte value.
• Down Arrow Click - Decreases the lower bound by one with a
minimum of 00 Hex.
Cyclone MAX User Manual