Related Manuals for INVISIBLE FENCE Indoor Micro Shields
Summary of Contents for INVISIBLE FENCE Indoor Micro Shields
- Page 1 ® Shields Avoidance Solutions ® Indoor Micro Shields Owner’s Manual Please read this entire guide before operating. www.invisiblefence.com...
-
Page 2: Important Precautions
• Invisible Fence ® Brand pet containment systems have contained over two million pets. However, there are some precautions you should take. • Read and retain manuals: Read the entire Owner’s Manual before using your new Indoor Micro Shields ® solution. ®... -
Page 3: Table Of Contents
® The Indoor Micro Shields solution gives you control over the areas a pet or pets have access to inside ® your home. It is designed to work independently or to complement your Invisible Fence Brand Boundary ® ® Plus and/or 800 Series digital electronic pet containment system. -
Page 4: Components
AC Adapter ® The AC adapter (RAC00-13701) is intended for long-term use or for recharging the Indoor Micro Shields transmitter. Use the AC adapter to charge the battery pack for a minimum of 4 hours prior to first use. Note: A correction is a training term used to describe an action taken to discourage unwanted pet behavior. The ®... -
Page 5: Operating Guide
• To charge the battery, plug one end of the AC adaptor (RAC00-13701) into a standard wall outlet and the other ® end into the power jack located on the edge of the Indoor Micro Shields transmitter. • Allow the unit to charge a full 4 hours before first use. A charge time of 2 hours is required after the first charge. -
Page 6: Changing The Channel Setting On The Indoor Micro Shields ® Transmitter
3. Locate the switch for the Channel (A), Channel (B) and Channels (A+B). (Figure 1) ® 4. Select the desired setting. Note: The Indoor Micro Shields transmitter will not enter into programming mode if this switch is set to A+B. -
Page 7: Multi-Area Shielding
® Computer Collar unitprogrammed to Channel B. • ® When set to Channel A-B (CH. A and CH.B), the Indoor Micro Shields transmitter denies access to all ® pets wearing a Computer Collar unit. Programming the Computer Collar® unit ... -
Page 8: Training Guide
Training Guide For pets trained to the Invisible Fence®Brand system • Use Invisible Fence ® Brand training flags to mark the outside of the signal field range. This gives your pet a visual marker, similar to how they learned the signal field range of the outdoor pet containment system. -
Page 9: Troubleshooting
• Check/replace the Power Cap Pet seems to ® ® Battery in the Computer Collar unit. • Check the signal field range on the Indoor Micro Shields ® receive no transmitter. • Ensure post covers are removed from the Computer Collar ®... -
Page 10: Battery Disposal
(1) Lithium (Li-MnO2) battery with a 3 Volt, ® 160 mAh capacity, replace only with equivalent battery that may be obtained from your Invisible Fence Brand dealer. The transmitter operates on 1 rechargeable Lithium Ion Polymer (Li-ion) battery pack with a 3.7 Volt, 420 mAh capacity. -
Page 11: Compliance
Compliance US and Canada FCC ID: KE3-3002563 IC: 2721A-3002563 This device complies with Industry Canada rules. This device complies with part 15 of the FCC Rules. Operation is subjectto the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 12 Dealer Name: Dealer Phone: System Frequency: Notes: 800-578-3647 (USA) (865) 777-5404 (International) ® ©2012 Radio Systems Corporation Need to remove the symbol here. All rights reserved. Protected by Patents: U.S.: 7,046,152; 7,068,174; 7,204,204; 7,278,376; 7,495,570 www.invisiblefence.com 12 ...
Need help?
Do you have a question about the Indoor Micro Shields and is the answer not in the manual?
Questions and answers