CHEST FREEZER USER'S MANUAL PCF 1002 i PCF 1452 i PCF 2002 i PCF 2602 i...
Page 2
Dear customer, Thank you for buying a PHILCO brand product. So that your appliance serves you well, please read all the instructions in this user's manual.
Page 3
CONTENTS PART 1: SAFETY INFORMATION ........................2 • Children and vulnerable people safety ...........................2 • General safety ....................................2 • Daily use ......................................3 • Care and cleaning ...................................3 • Installation ......................................3 • Service ........................................4 • Energy saving ....................................4 • Environment protection ................................4 PART 2: OVERVIEW ............................
PART 1: SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and fi rst using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
- avoid open fl ames and sources of ignition - thoroughly ventilate the room in which the appliance is situated It is dangerous to alter the specifi cations or modify this product in any way. Any damage to the cord may cause a short circuit, fi re and/or electric shock.
Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve suffi cient ventilation follow the instructions relevant to installation. Wherever possible the spacers of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn.
PART 3: INSTALLATION Install door external handle (if external handle is present) Step 1 Step 1 Pick out the screws 2 on the freezer cabinet and door by tools, total 7 pieces and Pick out the handle base with lock 1 handle cover 3, and lock ring 4 Step 2 Step 2 Fix the handle base 1 on the door by driving 5 pieces of screws picked...
Page 9
Step 4 Step 4 Fix the lock ring 4 on the freezer cabinet using the balanced 2 screws 2 Note NOTE: If the lock ring failed to hold the lock when installing handle, please unscrew the round head screws 5 on the back of door and adjust the position of door upper and lower.
Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm.
PART 4: DAILY USE First use Cleaning the interior Before using the appliance for the fi rst time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand new product, then dry thoroughly. IMPORTANT! Do not use detergents or abrasive powders, as these will damage the fi nish.
2.1 Power On & Power Off If the appliance is working, press “ON/OFF” for 3 seconds to turn off . If the appliance is off , press “ON/OFF” for 3 seconds to turn on. 3.0 Indicator Lights Temperature Indicator Light (Bright Blue): To adjust the temperature from Scale MIN to Scale MAX.
Helpful hints and tips Hints for freezing To help you make the most of the freezing process, here are some important hints: the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; ...
Do not allow such substances to come into contact the appliance parts. Do not use any abrasive cleaners Remove the food from the freezer. Store them in a cool place, well covered. Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker of fuse.
Troubleshooting CAUTION! Before troubleshooting, disconnect the power supply. Only a qualifi ed electrician of competent person must do the troubleshooting that is not in this manual. IMPORTANT! There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution Appliance dose Mains plug is not plugged in or is loose...
Replace the lamp The switch of LED lamp is gravity controlled, when the angle of door-opening is bigger than 30. Degree, light will switch on and switch off when the angle is smaller than 30 degree. NOTICE: When LED lamp does not work when door is open, please contact with staff of after-sale service for assistance.
Need help?
Do you have a question about the PCF 1002 i and is the answer not in the manual?
Questions and answers