Related Manuals for Siamp STORM 33A
Summary of Contents for Siamp STORM 33A
- Page 1 N 50 SINGLE FLUSH VALVE STORM 33A BOTTOM INLET VALVE COMPACT 99B ASSEMBLY INSTRUCTIONS...
- Page 2 DESCRIPTION...
- Page 3 PARTS SUPPLIED FITTINGS SUPPLIED Spanner Pushbutton Valve body Bolt Rubber Washer Sealing washer Fixing nut Washer Sealing Gasket Inlet valve Butterfly nut Inlet Rubber Washer (1) Spare Diaphragm Washer (1) Backnut Tools required (not spplied): • Slotted screwdriver and adjustable spanner.
- Page 4 I - ASSEMBLING THE INLET VALVE Place Inlet valve (F) through Inlet hole with inlet Rubber Washer (G) inside the cistern. Secure with backnut (H) but ensure float moves freely up and down valve body. NB : Manually screw the backnut until it is in contact with the ceramic.
- Page 5 III - ASSEMBLING CISTERN TO PAN Slide sealing gasket (E) over fixing nut Slide cistern onto W.C. backplate by Cistern locating screws through W.C. Secure using butterfly nut (N). Butterfly nut (N) IV - ADJUSTMENT OF VALVE HEIGHT Try the lid on the cistern to see if the valve is too high or too low : To adjust : Remove clips (x2) (1)
- Page 6 3 - Do not use connector handling the internal part of the inlet valve. SIAMP will be not responsible in case these warnings are not respected. Allow cistern to fill and by screwing the grey bolt slide the float to set water level to waterline.
- Page 7 THE FINISHED ASSEMBLY INSIDE THE CISTERN MAINTENANCE Servicing the valve To access the valve, unscrew the assembly as shown. To change the diaphragm washer inside the inlet valve Turn off the water supply to the inlet valve. Unscrew the knurled nut at the top of the inlet valve Remove the black rubber diaphragm washer...
- Page 8 SINGLE FLUSH VALVE STORM 33A BOTTOM INLET VALVE COMPACT 99B 4, quai Antoine 1 - BP 219 - MC 98007 MONACO Cedex N 100 N 50 Tél. 00 377 93 15 53 75 - Fax : 00 377 92 05 71 04 E-mail: contact@siamp.com...
Need help?
Do you have a question about the STORM 33A and is the answer not in the manual?
Questions and answers
Lost small white threaded collar that I think goes inside push button to increase the length (slightly) of flush push,can you advise many thanks