Advertisement
Quick Links
For The Warranty Terms & Conditions, Please Refer To Warranty Certificate.
INSTANT WATER HEATER
EWH-G3660(SW)
EWH-G3661(SW)
EWH-G3661(MB)
Please read this manual carefully before operating your set.
Retain it for future reference.
Record model number and serial number of the set.
See the label attached on the set and quote this
information to your dealer when you require service.
1
MODEL: ATTIVO SERIES
EWH-G3663AC(SW)
EWH-G3663AC(MB)
Owner's Manual
Advertisement
Related Manuals for Elba EWH-G3660(SW)
Summary of Contents for Elba EWH-G3660(SW)
- Page 1 INSTANT WATER HEATER MODEL: ATTIVO SERIES EWH-G3660(SW) EWH-G3663AC(SW) EWH-G3661(SW) EWH-G3663AC(MB) EWH-G3661(MB) Owner’s Manual Please read this manual carefully before operating your set. Retain it for future reference. Record model number and serial number of the set. See the label attached on the set and quote this information to your dealer when you require service.
- Page 2 ELBA The appliance is not be used by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Page 3 Power LED Heater LED ABS Front Cover Temperature Control Knob INTERNAL PARTS IDENTIFICATION ABS Heater Base Alternative Cable Entry ELCB Control Board Terminal Block LED Display Board Booster Pump Heater Tank Triac Heater Control Unit TEST & RESET PCB Flow Sensor Assembly Booster Pump ON/OFF Switch Water OUTLET...
- Page 4 1. ACCESSORIES Wall Bracket Hand Shower Shower Holder G1/2 Slider Railbar Wall Bracket 150mm Flexible Hose...
- Page 5 The appliances should be connected to the water mains with NEW hose- sets. Old hose-sets should not be reused. Instantaneous water heater’s shall be equipped with a 2 pole control switch and is own residual current device. 10. Water heaters exceeding 3kW shall be permanently connected to a 20A/30A rated circuit breaker / fuse with an isolator switch and residual current device.
- Page 6 2. INLET and OUTLET connection of the heater unit should not be reversed, with stop valve installed on INLET. (Diagram 1) stop valve incoming water INLET OUTLET (Diagram 3) a) Connect the stop valve to INLET, and be sure to put a gasket to prevent water leakage, SAFETY PRECAUTION Do not install reverse INLET and OUTLET of heater...
- Page 7 Restore cover c) Restore the cover and secure screw at the bottom. (Diagram 4) d) Align the knob, from ‘OFF’ position in clockwise direction to ‘MAX’ and return to ‘OFF’ mark as shown (Diagram 5) Diagram 4 STEP 1 STEP 2 Diagram 5 b) Switch on the main power supply (“POWER”...
- Page 8 Switch on the main power supply, the ‘POWER’ LED would light up. Switch off the power supply when not in use. damp cloth stop valve Filter Mesh CLEAN FILTER Diagram 6 MESH REGULARLY 3) THE SPRAY HEAD MUST BE DESCALED REGULARLY...
- Page 9 3.6kW 240V 50/60Hz Please refer Electrical loading Table 1 6 bar ( 0.6MPa / 87psi ) 440(H) x 190(W) x 89(D) Non Pump 1.4kg AC Pump 2.2kg Notes: The specification, actual product’s design and accessories parts shown are correct at the time of printing and subject to change without prior notices.
- Page 10 NON -PUMP (EWH-G3660/G3661)
Need help?
Do you have a question about the EWH-G3660(SW) and is the answer not in the manual?
Questions and answers