Table of Contents
Advertisement
Global LCD Panel Exchange Center
6.3 Power ON/OFF Sequence
: To prevent a latch-up or DC operation of the LCD module, the power on/off sequence
should be as the diagram below.
Power Supply
0.5 < < < < T
1
0 < < < < T
≤ ≤ ≤ ≤ 50 msec
2
0 < < < < T
≤ ≤ ≤ ≤ 50 msec
3
500 msec ≤ ≤ ≤ ≤ T
Back-light
200 msec ≤ ≤ ≤ ≤ T
200 msec ≤ ≤ ≤ ≤ T
NOTE.
(1) The supply voltage of the external system for the module input should be the same
as the definition of V
(2) Apply the lamp voltage within the LCD operation range. When the back-light turns on
before the LCD operation or the LCD turns off before the back-light turns off, the
display may momentarily become white.
(3) In case of V
a high impedance.
(4) T4 should be measured after the module has been fully discharged between power
off and on period.
(5) Interface signal shall not be kept at high impedance when the power is on.
6DPVXQJ 6HFUHW
Doc.No.
LTN133AT08-101
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
0.9 V
DD
V
DD
0.1 V
DD
0V
≤ ≤ ≤ ≤ 10 msec
T
4
Signals
0 V
Power On
5
6
Power ON/OFF Sequence
T1 : Vdd rising time from 10% to 90%
T2 : The time from Vdd to valid data at power ON.
T3 : The time from valid data off to Vdd off at power Off.
T4 : Vdd off time for Windows restart
T5 : The time from valid data to B/L enable at power ON.
T6 : The time from valid data off to B/L disable at power Off.
.
DD
= off level, please keep the level of input signals on the low or keep
DD
Rev.No
www.panelook.com
1
T
2
VALID
50%
50%
T
5
04-A00-G-080929
Approval
0.9 V
DD
0.1 V
DD
T
3
T
4
Power Off
T
6
Page
www.panelook.com
19
/ 30
Advertisement
Table of Contents
