Avaya 1230 Administration page 129

3. Configure the IP Deskphone Device Settings TFTP IP address to the IP address where your
TFTP server is running.
After you are finished the configuration, the IP Deskphone reboots and sends a request to
the TFTP server.
4. Select the Apply&Reset context-sensitive soft key to save the settings and reset the
IP Deskphone.
The following messages display on the IP Deskphone as the IP Deskphone cycles through
the conversion process, one after the other:
a. [FW] Reading...
b. [FW] Writing...
c. [FW] Finished...
The IP Deskphone then boots up with SIP Software.
If the conversion is unsuccessful, see the chapter
1. TFTP file transfer takes approximately 15 seconds.
2. File writing takes 2.5 minutes. The IP Deskphone displays the message [FW] writing....
3. After the new SIP software writing is finished, the IP Deskphone displays [FW] Finished.... and
then reboots.
4. The first time the SIP software boots, the SIP software performs a Flash File System conversion
that takes 2.5 minutes.
March 2015
Convert UNIStim software to SIP software on the IP Deskphone
SIP Software for Avaya 1200 Series IP Deskphones-Administration
Comments? infodev@avaya.com
Maintenance on page 328.
129