Table of Contents
Advertisement
3)
If you do not want to proceed with erasing the codes, press the N
button to exit. A message of "command cancelled" will show up.
4)
If you do wish to proceed to erase the codes, then press the Y
button.
5)
If the codes are cleared successfully, an "ERASE DONE!"
confirmation message will show on the display. Press any button
to return to the previous menus.
6) If the codes are not cleared, then an "ERASE FAILURE!"
message will appear. Press the N button to return to previous
menus.
Viewing ECU Information
1)
To view
to select ECU
press the Y button.
If the scan tool is not connected or no communication is
●
established with the vehicle yet, then refer to Reading Codes
from 1 to 7 at Paragraph 3.1.
< V2.6 USB-V1.9 SERIAL SOFTWARE
< V2.6 USB-V1.9 SERIAL SOFTWARE
Erase Codes
Erase Trouble Codes!
Are you sure?
<YES>
ECU Information
Information
Select Function
1) Read Code
2) Erase Code
►3) ECU Information
4) Readiness Test
NO
, use the UP/DOWN scroll buttons
from Select Function menu and
14
14
V
Advertisement
Table of Contents
