Related Manuals for Titan TS 131A
Summary of Contents for Titan TS 131A
- Page 1 OWNER'S GUIDE OWNER'S GUIDE ADV ANCED REMOTE STARTER ADV ANCED REMOTE STARTER FOR AUTOMATIC TRANSMISSION ONLY FOR AUTOMATIC TRANSMISSION ONLY www.titan-innovations.ca www.titan-innovations.ca Revision 1.01...
- Page 2 The owner/user MUST INSTALL a CARBON MONOXIDE DETECTOR in the living area near to where the vehicle is being stored or parked. It is the sole responsibility of the owner/user to keep the remote transmitters away from the reach of children and handle with care so that the system does not unintentionally start.
- Page 3 Button Operations Lock Unlock Car Finder Start ACTION FUNCTION Press LOCK button once Locks doors* and activates Starter Disable** Press LOCK once then press and hold Window Roll-up*** Unlocks doors* and deactivates Starter Disable** Press UNLOCK button once Press and hold LOCK for 3 sec Remote panic* Trunk release*...
- Page 4 LOCK A. Press LOCK button momentarily. B. Parking lights will flash 1 time, horn will honk 1 time*, doors will lock. C. The LED on the antenna will begin to flash slowly. D. If the optional starter-disable circuit has been installed, it will activate as well. UNLOCK A.
- Page 5 TRUNK RELEASE --OPTIONAL-- The vehicle must be equipped with a power trunk release switch or a power sliding door to use this option. A. Press and hold the UNLOCK button. B. The doors will unlock and after 3 seconds, the trunk release will activate. C.
- Page 6 IDLE MODE (CONTINUOUS RUN) This option allows you to remove your key and leave the engine running up to the programmed runtime A. With the engine running, press the START button. B. The Horn will chirp twice* and the remote starter will come on. C.
- Page 7 TIMER START MODE This option allows you to start your vehicle automatically at preset intervals over a 24-hour time period. A. Press and release the CAR FINDER button, then press and hold the START button for about 3 seconds until the parking lights turn on. B.
- Page 8 TRANSMITTER LEARNING Important! The remote starter will hold 4 transmitter codes. It is recommended that when programming in transmitters, you fill up all four transmitter codes, even if only using one or two transmitters. This will clear all other transmitter coding from the unit and prevent stray coding or possible interference from other remote transmitters.
- Page 9 SERVICE (VALET) MODE 5 secs...
-
Page 10: Battery Replacement
Diagnostics If the remote starter does not activate when the button is pressed, the park lights will flash a diagnostic code to indicate what shutdown input has been triggered. Flashes Problem Solution System is in valet mode Cancel Valet Mode 3 slow flashes 4 slow flashes Door Open... - Page 11 The manufacturer warrants to the original purchaser of the remote starter and/or alarm, that the product shall be free from defects in material and workmanship. However, should this product be proven to be defective, within a three year period from the original date of purchase, the manufacturer will, without charge to the purchaser (excluding any charges incurred to have the product delivered to the manufacturer), repair or replace any part of the remote starter and/or alarm which the manufacturer agrees to be defective.
- Page 12 FCC/ID Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the TS 131A and is the answer not in the manual?
Questions and answers