Table of Contents
Advertisement
Aim Brightness
Parameter # F1h 9Ch
This feature sets the brightness of the aim pattern. The default is 0, which indicates that the aim pattern is always
on in between camera exposures. For values above 0, each increment of the brightness value increments the aim
duration 0.5 ms.
To program Aim Brightness, scan this bar code followed by three numeric bar codes in
Codes
that correspond to the value representing brightness. Settings range from 0 to 255. The maximum aim
duration is limited by the frame time, so the recommended range is 0 to 30 when the frame rate is set to 60 fps.
Aim Brightness
Illumination Brightness
Parameter # F1h 9Dh
This feature sets the brightness of the illumination by altering LED power. The default is 10, which is maximum LED
brightness. For values from 1 to 10, LED brightness varies from lowest to highest level of brightness.
To program Illumination Brightness, scan this bar code followed by two numeric bar codes in
Bar Codes
that correspond to the value of desired illumination brightness. For example, to set Illumination
Brightness to 6, scan the bar code below followed by the 0 and 6 bar codes.
Imager Preferences
Appendix D, Numeric Bar
Appendix D, Numeric
Illumination Brightness
5 - 7
Advertisement
Table of Contents
