Mounting The Right And Left Fenders - Kubota B1220 Assembly Instructions Manual

6 ASSEMBLY INSTRUCTIONS
BMounting the Right and Left Fenders
1. Move the left-side two levers of the tractor to the low
position.
2. Tilt the front of the left-hand fender (1), insert the two
levers (2) in the lever guide (3).
3. For the right-hand fender, insert the levers in the lever
guide.
4. Secure the fender (LH and RH) (1) with the four M8
bolts (2).
BInstalling the Lever Grip
Install the lever grips onto the control levers. See the
figure.
(1) Yellow 83
(2) Orange 63
(3) Lever grip (main gear shift )
(4) Orange 63 [B1620, B1820, B1820ACE]
(5) Black 83
A Apply rubber-bonding adhesive to the lever before
installing the lever grips to permanently secure them.
BAttaching the 3-Point Hitch Assembly
1. Attach the top link (1) to the top link bracket (2) with the
joint pin and the set pin.
A The upper hole on the top link bracket (2) is normally
used for mounting.
2. Attach the lift rod (3) to the lift arm (4) with the joint pin
and snap ring.
3. Grease all screws and rotating parts of the 3-point
hitch until movement is smooth.