Table of Contents
Advertisement
z Detaching the Cover
Detach the front cover from the iris reader by removing the
tamperproof screws with the supplied tamperproof screw
driver tool.
The tamperproof screw holes are
inclined to the front side approx. 15
as you can easily fasten the screws
while the iris reader is mounted to the wall.
Remove the tamperproof screws with the
supplied tamperproof screw driver tool.
Note: Be sure to shut down the power supply before
detaching the front cover from the iris reader. If the
power is being supplied when the front cover is
detached, the iris reader will enter the "tamper detec-
tion" mode and the buzzer will beep. In case the power
supply cannot be shut down, detach the front cover
from the iris reader and cancel the "tamper detection"
mode by moving Setup Switch 3 to ON. The buzzer
sound will be stopped.
x Setup Switch Setting for Setup
Before starting the setup, move Setup Switch 1 to OFF and
Setup Switch 3 to ON to cancel the "tamper detection"
mode.
ON (Upper side)
1 2 3 4
°
Approx. 15
°
Tamperproof screws x 2
c Connection between the Iris Reader and
Setup PC
Connect the iris reader and setup PC with the exclusive
setup cable supplied to the administration software.
Attach the round connector of the cable to the setup cable
connector of the iris reader, and then attach the D-sub 9
pin connector of the cable to the serial port of Setup PC.
(When attaching the round connector to the iris reader,
direct the cable to the left of the connector.)
v Supplying the Power to the Iris Reader
Turn on the power of the external power-supply device.
Wait until the guide and result indicator goes out.
b System Setup
The following is how to boot the setup software.
1. Double-click "BM-ET330 SetupSoftware" in the
folder designated at the time of installation.
"BM-ET330 Login" window will appear.
2. Select the COM port to which the iris reader is
connected, and then enter the password.
• Available characters (Capital and small letters are dis-
tinct.): ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefghij
klmnopqrstuvwxyz0123456789
• 6 to 16 characters are available.
• Default password: BMET330
When the password is accepted, the current setting is
read from the iris reader into the setup software. (The
reading may take a few seconds.)
After the setting is read into the software, the
"Completed." window will appear. When you click on
"OK", the "BM-ET330 setup software" window will
appear. (Refer to p. 14.)
13
Advertisement
Table of Contents
