Trim Position Sender Adjustment; Trim Limit Switch Adjustment - Mercury BRAVO Service Manual

SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY

Trim Position Sender Adjustment

1. Turn ignition key to the RUN position. DO NOT START ENGINE. Rotate trim position
2. Tighten trim position sender retaining screws and recheck gauge.

Trim Limit Switch Adjustment

When adjusting trim limit switch, use extreme care that engine is not started and
keep clear of area near propeller. Use care to prevent placing hands in an area where
injury could occur because of sterndrive unit movement.
Trim limit switch MUST BE adjusted exactly as outlined. If switch is adjusted incor-
rectly, sterndrive unit could move out beyond the gimbal ring support flanges and
cause damage to sterndrive unit.
1. Adjust trim limit switch as follows:
Page 4A-16
sender until needle is at bottom of arc on gauge.
a. Loosen screws and turn trim limit switch clockwise to end of slots.
a - Screws
b - Slots
b. Ensure that sterndrive unit is in the full DOWN/IN position.
c. Trim sterndrive unit UP/OUT. Do not use trailer switch.
WARNING
CAUTION
a
b
SERVICE MANUAL NUMBER 28
22175
71221
90-863160 MAY 2000