Wittenborg IN 7600 Quick Reference Manual page 3

Display
message
Cup blocking the movement of the
Branch
branch pipe.
pipe error
Grease or dirt blocking the movement
of the branch pipe.
Cup
elevator
Cup on elevator when machine is
error
switched on.
Cup not
delivered
No more cups.
Dirt or grease blocking cup slide.
or
No cups in cup magazine
Use own
cup
Cup
Cup pile blocked.
storage
error
Cup
Cup slide blocked.
transport
error
Door not closed properly.
Door open
Waste bucket full.
Waste
bucket full
Waste bucket sensor soiled.
Temperature
The machine has been turned on
low
recently.
Overboil thermostat has triggered.
Water tank
overboil
If it was impossible to remedy the fault, or other type of display message is shown,
please contact the service.
3
Reference Card Error Types
Possible cause Possible action
Switch machine OFF and ON.
Remove cup.
Clean cup catcher and cup slide areas.
Remove cup.
Load cups in cup magazine.
Clean cup slide.
Use own cup / load cups in cup
magazine.
Remove blocking cup.
Remove blocking cup.
Close door properly.
Empty waste bucket and wipe dry
sensor.
Clean and wipe dry sensor.
Wait until the water is heated sufficiently
(maximum 13 minutes).
Press reset button.