Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Chemin'Arte 144
Summary of Contents for Chemin'Arte 144
- Page 1 Instruction manual for ceramic heaters Chemin’Arte 1000/1500W (ref 144 et 145)
- Page 2 Before use : Check whether the electricity supply meets the voltage requirement. • Do not place the appliance near combustible materials, such as curtains, furniture... • Do not use outdoors, or on or near direct heat sources. • The heater must not be used in a bathroom or near a source of water. •...
- Page 3 • Make two holes in the wall bearing in mind that the distances will vary depending on the type of heater that you have purchased. Model 1000W (ref 144) : 420mm between holes Model 1500W (ref 145) : 560mm between holes Attach the brackets (4) to the wall using the retaining studs and screws enclosed.
- Page 4 Finally hang the appliance on the brackets and screw the mounting plate to the wall. Use: AUTOMATIC LOCKING The buttons on the heater become blocked in the display ( ) , if during operation no key is pushed during one minute. To unlock them you must press (-) for 3 seconds.
- Page 5 () will disappear from the screen. • When the temperature drops below that programmed the device will connect automatically and the power indicator () will reappear on the screen. NOTE: The power indicator () may flash when the reference temperature is approaching the point of connection and disconnection.
- Page 6 • Unlocking the appliance. To do this, hold down “PROG” for a few seconds until the display shows “00:00”. The first two digits corresponding to the time work intermittently. Using the + o - , keys set the actual time and push “PROG” so that the time remains set.
Need help?
Do you have a question about the 144 and is the answer not in the manual?
Questions and answers