Joseph Enterprises The Clapper Plus Manual

With remote control

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Joseph Enterprises, Inc.

425 California Street, Suite 300

San Francisco, California 94104

Table of Contents

Need help?

Do you have a question about the The Clapper Plus and is the answer not in the manual?

Questions and answers

Summary of Contents for Joseph Enterprises The Clapper Plus

Page 1 Joseph Enterprises, Inc. 425 California Street, Suite 300 San Francisco, California 94104...
Page 2 RF (Radio Frequency) remote control. With The Clapper Plus, you can turn on or off up to two different appliances by clapping your hands. Clap two times to operate one appliance and three times to operate a different appliance.
Page 3 2 Clap Socket 3 Clap Socket Clap Indicator Sensitivity Dial Lights Microphone Home/Away Switch Operates appliance plugged Operates into socket II appliance plugged into socket III — 3 —...
Page 4 ½ second long. The three pauses after the second clap are very important since the Clapper Plus must determine that you are not going to clap a third time. If you did clap a third time, the appliance connected to the III clap receptacle would activate..
Page 5 Adjust it down to reduce the Clapper from detecting unwanted noise. 3. Plug an appliance into bottom receptacle (III) of the Clapper Plus. 4. Plug Clapper Plus into the wall socket. 5. Make sure any power switches on the appliance or lamps are in the on position.
Page 6 Clap Detection Lights The three red lights on the face of the Clapper Plus will help you determine the proper way to clap your appliances on or off. Each clap detection light will glow when a proper clap (or similar sound) is detected.
Page 7 (as described above). 2. Plug an appliance into Top or Bottom receptacle of the Clapper Plus. 3. Plug the Clapper Plus into the wall socket. 4. Make sure any power switches on the appliance or lamps are in the on position.
Page 8 Press, hold and release the II button to turn on the appliance plugged into the Top (II receptacle) of the Clapper Plus. Press it again to turn it off. Press, hold and release the III button to turn on appliance plugged into the bottom (III receptacle) of the Clapper.
Page 9 When in the AWAY mode, both appliances will turn on with the detection of any sound. To operate The Clapper Plus in the AWAY mode 1. Slide the Home/Away switch to the Away position. Both attached lamps will turn on for 10 seconds. This allows you to leave the room with the lights on.
Page 10 1. If the Clapper Plus does not turn on while Clapping a. Make sure the Clapper Plus is plugged in properly. When the clapper is first plugged in the red lights on the front of the Clapper Plus will sequence through a startup pattern.
Page 11 Make sure the battery is good and install correctly b. Move the Remote to another position. Move it up or down or move it closer to the Clapper Plus. Keep the Remote away from metal objects or walls that will interfere with the Radio waves.
Page 12 Each Clapper Plus and its remote can be set to channel 1, 2, 3 or 4. When first plugged in, the Clapper Plus unit start out set at channel 1. When the battery is put into the remote, the remote’s channel is also set to 1.
Page 13 (lamps) plugged into the Clapper Plus base unit, but when both are pressed at the same time, they are used to set the channels on the Remote and also send a signal to the Clapper Base unit to set its channel.
Page 14 This is easy because it happens automatically each time you press one of the remote’s buttons. The Clapper Plus base will display (after 4 seconds) the channels by flashing the Red lights on the Clapper.
Page 15 1. Do not use The Clapper Plus with any electrical heating appliances such as toasters, hair dryers, coffee pots, etc. 2. Do not use The Clapper Plus with any appliance that can create a fire hazard with prolonged use. 3. The maximum wattage for an appliance is 200 watts in either outlet.
Page 16 Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Warning (Part 15.21) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate...
Page 17 WE WELCOME YOUR FEEDBACK Please feel free to write us at: jei@jeiusa.com or mail to: JOSEPH ENTERPRISES 425 California Street #300, San Francisco, CA 94104 Many questions can be answered by listening to our pre- recorded Clapper Plus Hotline at 800-557-5856.
Page 18 Should The Clapper® prove to be defective within the thirty (30) days from the date of purchase, the product will either be repaired or replaced, at Joseph Enterprises’ discretion, free of charge. To receive warranty service, return the product insured, along with proof of purchase included on the back of the product.
Page 19 Important: The Clapper Plus® must be insured if its returned — Joseph Enterprises cannot assume any responsibility for loss or damage to uninsured shipments. A copy of the sales receipt or other proof of purchase MUST be enclosed with the returned merchandise to qualify under the terms of the warranty(please do not send the original document).