Cleaning; Limited 6 Month Warranty; Error Codes - Avantco ID1800 User Manual

ERROR CODES

Cause
E0
No cookware on plate or non-usable cookware.
The cooker has become too hot.
E1
(e.g. due to blocked ventilation slots)
Overheating protection was activated and the cooker
E2
has switched off.
E3
Temporary voltage overload. Cooker became too hot.
NOTE:
For added precaution, if you receive error codes E1, E2, or E3, unplug the unit immediately and let it cool down completely.

Cleaning

WARNING! DANGER OF BURNING AND ELECTRIC SHOCK.
ALWAYS SWITCH OFF AND UNPLUG APPLIANCE AFTER USE AND BEFORE CLEANING.
LET THE APPLIANCE COOL DOWN BEFORE CLEANING AND STORAGE.
NEVER IMMERSE THE APPLIANCE IN WATER OR CLEAN IT UNDER RUNNING WATER.
1. Disconnect plug and wait until the unit has cooled down completely. Clean after using every time.
2. If the pots/pans are used without being cleaned, discoloration or cooked-on stains may be caused.
3. DO NOT use benzine, thinner, scrubbing brush, or polishing powder to clean the induction cooker.
4. Wipe using dish washing agent and damp cloth. Make sure the unit dries completely before plugging it back in.
5. Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.
6. NEVER run water over the unit (water that gets inside may cause malfunction).

Limited 6 Month Warranty

All equipment, which is sold under the AVANTCO trademark and used for commercial purposes, is warranted against
defects in materials and workmanship. The warranty runs for 6 months from the date of purchase and is for the benefit
of the original purchaser only. All other Warranties, Expressed, or Implied, Statutory or Otherwise, including Without
Limitation any implied Warranty of Merchantability or Fitness for Purposes are excluded. The Seller shall in no event be
liable for direct, indirect or consequential damages in connection with AVANTCO commercial products.
This warranty is not effective if damage occurs because of accident, carelessness, improper installation, lack of proper
set – up, supervision when required of if the equipment is installed or operated in any manner contrary to the
installation and operating instructions. Using pans with a bottom diameter greater than 10 1/4" voids the warranty.
www.AvantcoEquipment.com
User Manual
Solution
Place suitable cookware on cooking plate.
Clear vents, let cooker cool down before restarting.
If error message continues, contact manufacturer.
Remove cookware from cooker and let unit cool down
before restarting.
Let cooker cool down before restarting.
5