Safety Regulations - Valeo THERMO DC 200 Installation And Operation Instructions Manual

Thermo DC 200
2

Safety regulations

Warning!
Installation, maintenance and repairs may only be carried out when
the vehicle's engine is not running and the high voltage supply is
switched off.
Before starting the work at the heater, it is to make voltageless acc.
to DIN VDE 0105-100 and this state must be ensured for the dura-
tion of the work.
In particular, the following safety precautions must be observed:
– switch off the power supply to the heater
– ensure it cannot be switched on again
– verify, system is voltage-free, all poles
– ground and short circuit
– cover or block neighbouring parts under voltage
Electrical cables and operating elements of the heater must be ar-
ranged in the vehicle in such a way that their functioning is fault-
less under normal operating conditions and cannot be hampered.
Work at electrical equipment may only be started if protective
measures against electric shock, short circuits and arcing faults
have been carried out.
Electrical work may only be performed by a qualified electrician for
HV systems in motor vehicles, craftsman, activity with repetitive
character. Training acc. to DGUV 200-005 (previously BGI 8686).
High voltage! Danger to life!
NOTE:
The provisions of these Regulations are binding within the territory
governed by DGUV Regulations and should similarly be observed in
countries without specific regulations.
Safety regulations
3