Advertisement
DVAS | Instruction Manual | Installation
By default the new page will request you to provide a
user name and password:
User name = ADMIN
Password = PASSWORD
Now the main frame should change to the main
Network Settings page. Insert the new setting into the
text boxes.
Figure 4
How to Set IP Address
Decide whether to use DHCP (Dynamic Host
Configuration Protocol) or a manually set IP address.
Use the radio buttons to select the desired value. If you
choose DHCP, you will not need to choose any further
values. It is recommended that you have your DHCP
server reserve a static IP for your DVAS series disk
array.
IP Address
Assuming you have chosen to set up the network
manually, enter a free IP address into the text box.
Subnet Mask
Type the subnet mask that fits the class of your
network. In most cases 255.255.255.0 is fine, but
Bosch recommends that you contact your IT
administrator for further assistance.
Gateway
Type the IP address of your Internet gateway into this
text box.
Bosch Security Systems | 07 January 2004
Primary/Secondary DNS
Type the IP address of both your Primary and
Secondary DNS into the supplied text boxes.
Web Page Auto Refresh
Determines whether the web pages should be reloaded
at a given interval in order to show any changes to the
system on screen. If you wish to use this, ensure that
the Enabled box is checked. You will also need to
specify a value in seconds to determine the frequency
the web page is refreshed.
When you have updated all these settings, hit the Save
Configuration button.
You will need to restart the system before these
changes take effect.
1.4
Quick Configuration
THIS PROCESS WILL CLEAR ALL
YOUR DATA!
The DVAS can be fully configured with the Quick
Config function. To access this function, click the
Quick Config button in the left hand menu of the main
web page.
When the Quick Config page loads, select one of two
configurations. These can be selected by clicking on
one of the two page tabs at the top of the page. 1 DVR
CONFIG should be selected if your unit is to be used
with a single DVR, however, you should use 2 DVR
CONFIG if you wish to attach two DVRs to the unit.
The selected DVR configuration tab will display the
status of the configuration identifying which settings
need configured.
EN | 10
Advertisement
