Diesel Particulate Filter (Dpf) Regeneration (Only Applies To Creader 7011F/9081); Tire Pressure Monitor System Reset (Only Applies To Creader 9081) - Launch CReader 6011 User Manual

LAUNCH
and battery matching will be done.
Battery matching must be performed in the following cases:
a) Main battery is replaced. Battery matching must be performed to clear original
low battery information and prevent the related control module from detecting
false information. If the related control module detects false information, it will
invalidate some electric auxiliary functions, such as automatic start & stop
function, sunroof without one-key trigger function, power window without
automatic function.
b) Battery monitoring sensor. Battery matching is performed to re-match the
control module and motoring sensor to detect battery power usage more
accurately, which can avoid an error message displaying on the instrument
panel.
5.3.5 Diesel Particulate Filter (DPF) Regeneration (Only applies to CReader
7011F/9081)
DPF regeneration is used to clear PM (Particulate Matter) from the DPF filter
through continuous combustion oxidation mode (such as high temperature
heating combustion, fuel additive or catalyst reduce PM ignition combustion) to
stabilize the filter performance.
DPF regeneration may be performed in the following cases:
a) The exhaust back pressure sensor is replaced.
b) The PM trap is removed or replaced.
c) The fuel additive nozzle is removed or replaced.
d) The catalytic oxidizer is removed or replaced.
e) The DPF regeneration MIL is on and maintenance is performed.
f) The DPF regeneration control module is replaced.

5.3.6 Tire Pressure Monitor System Reset (Only applies to CReader 9081)

This function allows you to quickly look up the tire sensor IDs from the vehicle's
ECU, as well as to perform TPMS replacement and sensor test.
1. After the tire pressure MIL turns on and maintenance is performed, the tire
pressure resetting function must be performed to reset tire pressure and turn
off the tire pressure MIL.
2. Tire pressure resetting must be performed after maintenance is performed in
the following cases: tire pressure is too low, tire leaks, tire pressure monitoring
device is replaced or installed, tire is replaced, tire pressure sensor is damaged,
and tire is replaced for the car with tire pressure monitoring function.
CReader Series English User's Manual
20