Typical Connection For Arcreach Stick/Tig Remote (Gtaw Process) - Miller XMT 350 Owner's Manual

7-2. Typical Connection For ArcReach Stick/TIG Remote (GTAW Process)

11
10
!
Turn Off welding power source be-
fore making any input or output
weld cable connections.
!
Turn Off welding power source be-
fore handling or moving voltage
sensing clamp. Weld voltage is
present at voltage sensing clamp
when welding power source is on.
This condition exists even if Polari-
ty Indicators and Amps/Arc Control
Display on this remote are not lit.
.
When the ArcReach Stick/TIG Re-
mote is connected to the power source
as electrode negative, the remote will
set the welding power source to a TIG
3
2
1
7
8
14
13
12
mode. The electrode negative (TIG) in-
dicator on the remote will be lit.
1 Negative (−) Weld Output Terminal
Connection for weld cable going to remote.
2 Gas Out Connection (Optional)
3 Positive (+) Weld Output Terminal
Connection for work cable going to
workpiece.
4 Gas In Connection (Optional)
5 Gas Cylinder
6 Welding Power Source
7 Female Connector (User Supplied
LC-40 Style Female Connector)
8 Input Weld Cable (With Supplied
Male Connector)
4
6
9
9 Voltage Sensing Lead
Attach voltage sensing lead clamp to
workpiece.
10 Workpiece
11 TIG Torch
12 Male Connector (User Supplied
LC-40 Style Male Connector)
13 Output Weld Cable (With Supplied
Female Connector)
14 ArcReach Stick/TIG Remote
.
An additional weld cable my be used in
parallel with the remote if weld current
exceeds amperage rating of the re-
mote.
5
Ref. 280219-A
OM-278618 Page 29