Kenwood DRV-N520 Instruction Manual page 9

Recommended installation position
• Install the device in a position where it will not block the front view of the driver
(position where hidden by the rear-view mirror).
• Install the device so that it is within the wiping range of the wiper.
• Mounting the device to the center of the windshield behind the rear-view mirror will
facilitate optimal video recording.
Outside
Windshield
vehicle
Rear-view mirror
Inside
vehicle
*Fix the power cord in place with commercially available
soft tape or the like.
CAUTION
When passing the power cord through the front pillar or another part, observe the
following points when performing the wiring work.
• Wire the power cord farther forward or farther rearward than the airbag so that it does not
interfere with the airbag.
• In the case of a vehicle in which the front pillar cover is fixed in place with special clips or the like,
the clips may need to be replaced after you remove the front pillar cover. For how to remove the
front pillar cover, the availability of replacement parts, and other information, contact the vehicle
dealer.
• Fix the power cord in place with commercially available soft tape or the like so that it does not
interfere with driving.
Example of Mounting
Ceramic part
Power cord1
Power cord1
Clip
Front pillar
cover
Soft tape*
Airbag
Front pillar
9