Program Your Remote Control - Samsung 8340 User Manual

pRoGRAM yoUR REMoTE CoNTRoL

To get the most out of your new terminal, we recommend that you read the next few pages to
ensure that you properly program your remote to your TV.
There are three ways to program your remote control:
1. Quick programming: for your TV only.
2. Programming using automatic search: for your TV or audio system.
3. Programming by code: for your TV or audio system.
qUICk pRoGRAMMING of yoUR REMoTE CoNTRoL
If your TV brand is not among the 10 brands listed below, please use the Automatic Search
Programming Method described on the next page.
1. Turn on your TV.
2. Hold down and
release both buttons.
3. Press once. The red light will stay lit.
4. Point the remote control at the TV. Refer to the table below and enter the number
corresponding to the brand of your TV (e.g. 2 for LG). The red light will blink twice and the
TV will turn off.
5. Press to lock the code.
6. Turn your TV back on. If this programming procedure did not work, repeat steps 2 to 5 or use
the Automatic Programming procedure described on the next page.
7. When your remote control has been programmed, we strongly recommend that you change
the volume control on the TV via the Equipment Settings (see the Equipment Settings section
on page 16).
NUmBER
1
2
3
4
5
For further information, visit videotron.com/terminal-support.
at the same time until the red light under
HD TV BRANDS
INSIGNIA
LG
MITSUBISHI
PANASONIC
PHILIPS/MAGNAVOX
blinks twice, then
NUmBER HD TV BRANDS
6 SAMSUNG
7 SHARP
8 SONY
9 TOSHIBA
0 VIZIO
13