Related Manuals for STATESMAN STUDIO2B
Summary of Contents for STATESMAN STUDIO2B
- Page 1 STUDIO2, STUDIO2B & STUDIO2S 50cm SINGLE BLACK CAVITY GAS COOKER Instruction Manual Please read these instructions carefully before use and retain for future reference...
-
Page 2: Table Of Contents
Contents Page Introduction............3 Safety (General) ..........4 & 5 Using the Oven………………………………..6 Using the Hotplate…………………………... 7 Using the Grill……………………………………… 7 Cleaning……………………………………………. 8 Installation ........... 9 & 10 LPG Conversion………………………………..11 Technical Data ..........11 Specification ............. 14... -
Page 3: Introduction
Introduction Thank you for choosing a STATESMAN appliance. Important: Before using your appliance, please read this manual carefully to assist safe and successful operation. Installation ( See Page 8) This cooker must be installed by qualified personnel, according to the manufacturers instructions and to the relevant British Standards. -
Page 4: Safety (General)
• This appliance must be installed and commissioned by a qualified person as Statesman will not take any responsibility for damage caused by incorrect installation. • Before installing this appliance, make sure that the gas and electricity supplies are compatible with the specification on the rating plate and the packaging. - Page 5 Safety (continued) • IF A REPAIR IS REQUIRED, ONLY GENUINE PARTS SHOULD BE USED AND ANY WORK MUST BE CARRIED OUT BY A QUALIFIED ENGINEER. • The installer of this appliance should read the installation instructions and should be a suitably qualified person. •...
-
Page 6: Using The Oven
Using the Oven OPERATION Open the door fully, push in and turn the oven control knob to max. Hold the control knob in and press the ignition button. Keep the oven control knob pressed in for a further 5 - 10 seconds before slowly releasing and turning to the desired temperature. -
Page 7: Using The Hotplate
Using the Hotplate IGNITION Push in and turn the selected control knob anticlockwise to the ‘full on’ position (as indicated by the flame symbols), whilst pressing the ignition button until the burner lights. If you have the FULL FFD model (LEGACY 50GSLF), YOU WILL NEED TO HOLD THE CONTROL KNOB IN FOR 5-10 SECONDS. -
Page 8: Cleaning
Cleaning IMPORTANT - Before any maintenance or cleaning can be carried out, the cooker must be un-plugged from the electricity supply. HOTPLATE The hotplate is best cleaned when it is still warm as it is easier to remove spillages before it has cooled. -
Page 9: Installation
Installation IMPORTANT - Installation of this cooker must be carried out by qualified personnel. CLEARANCES This cooker may be fitted flush to the base units. Leave a gap of approximately 2mm minimum from any adjacent cupboard or appliance. Any adjacent surface must be heat resistant to 50°C and if it is higher than the appliance it must be a minimum of 110mm away from the appliance. -
Page 10: Installation
Installation (continued) VENTILATION REQUIREMENTS This appliance needs 2m /h of air per kw input. This appliance must not be installed in a bed sitting room of less than 20m or in a bathroom or shower room. If there are other fuel burning appliances in the same room, BS5440; Part2; 1989 should be consulted to determine the air vent requirements. - Page 11 Installation (continued) ANTI-TILT DEVICE The cooker must be fitted with an anti-tilt /restraint device to prevent it tipping forward when in use. To use the floor mounted bracket supplied, see the instructions provided. LEVELLING Place a spirit level on an oven pan or shelf and adjust the feet accordingly. Make sure that the appliance is stable and does not rock.
-
Page 12: Lpg Conversion
LPG Conversion This cooker has been pre-set for use on Natural Gas. A conversion kit is included for converting the appliance for use on LP Gas. This should only be carried out by a suitably qualified engineer. CHANGING THE INJECTORS Refer to the table of injector sizes to select the correct injectors. - Page 13 LPG Conversion SETTING THE SIMMER RATES Hotplates. a) Models without hotplate FSD Each hotplate tap can be adjusted through the hole in the centre of the tap spindle. Set the lighted burner to the simmer position and remove the control knob.
-
Page 14: Technical Data
Technical Data GAS TYPE Nat Gas @ 20 mbar LPG - Propane @37 mbar LPG - Butane @ 28.3 mbar GAS CATEGORY Natural Gas - I 2H LPG - I3 + I3H AERATION Preset ELECTRICAL 220 - 240V 50Hz FUSE 3 Amp OVEN CAPACITY 50.5 Litres... -
Page 15: Specification
Specification Gas Type Small Medium Large Oven Grill Burner Burner Burner Burner Burner G20 20mbar 0.72 0.97 1.15 G25 25mbar 0.72 0.94 1.25 G30 30mbar 0.65 0.85 0.70 0.68 G31 37mbar 0.65 0.85 0.70 0.68 G30 50mbar 0.43 0.58 0.75 0.68 0.62 Natural Gas... - Page 16 38 Bluestem Road, Ransomes Europark Ipswich, IP3 9RR 0844 848 5861...
Need help?
Do you have a question about the STUDIO2B and is the answer not in the manual?
Questions and answers