Set Up Bluetooth Communication - Scantech V-1020BT User Manual

20
4.3

SET UP BLUETOOTH COMMUNICATION

Before the VEGA scanner can be used for normal operation, Bluetooth
communication must be set up between the VEGA scanner and cradle.
Pairing
4.3.1
Pairing refers to when a VEGA scanner has been linked or paired to a specific
cradle by scanning that cradle's Bluetooth MAC address code, this Bluetooth MAC
address code is unique for each cradle. This address code is located on the
bottom side of the cradle. The pairing of a VEGA scanner to a cradle is one to
one. Only one VEGA scanner can be paired to a cradle at any point in time.
Set up Client Mode Communication
4.3.2
To set-up the communication between the VEGA scanner and the cradle follow
the next steps:
1. The VEGA scanner must scan "Scanner Client Mode ON/Scanner Server
mode Off" barcode. To set the VEGA scanner in client mode.
2. Scan the Bluetooth MAC address code located on the bottom of the
cradle.
3. When the Bluetooth MAC was successfully scanned, scanner will initiate
with short beep sounds. Blue and red led will also blink followed by a long
beep sound. Blue led will turn off to finish the set up.
4. Wait approximately five seconds, for completing the connection process.
5. If successful, the blue led on the cradle will be on.
6. If the connections failed the scanner indicates with shot beep sounds and
the cradle with blinking blue led.
Installation of the VEGA V-1020BT