Page 1
AVERTISSEMENT: Veuiltez tire te manuet d'instructions avertissements et toutes tes instructions de te faire pourrait entrafner des btessures graves. Poulan PRO 1030 Stevens Creek Road Augusta, GA 30907 el aparato al lugar de compra. I'outil au detaillant. Instruction Manual...
Page 2
Failure to do so can result in serious 1 Read your operator's Hazard zone for thrown objects. standers, mum of 30 feet (10 meters) when starting unit. Do not point blower nozzle people or pets. 1Sec°rehairab°vesh°u'der'en0th , A w Yss°P cleaning Wt&.R NING:...
Page 3
• Keep children, bystanders, away from work area a minimum (10 meters) when starting or operating unit. Do not point the blower nozzle in the direc- from tion of people or pets CAUTION, HANDLE FUEL WITH...
• Never run unit without the proper equip- ment attached. When using your unit as a blower, always install blower tubes. When using your unit as a vacuum, always install vacuum tubes and vacuum bag assembly. Make sure vacuum...
A standard screwdriver is required for as- sembly. BLOWER TUBE ASSEMBLY 1. Align the fib on the upper blower tube with the groove in the blower outlet; slide the tube into place. NOTE: Knob must be loose enough to allow blower tube to be inserted in blower outlet.
2. Remove the vacuum tubes by turning tubes clockwise. inlet 3. Close the vacuum inlet cover sure it is tatched c{osed. 4. Reinstall the blower tubes (see SLOWER TUBE ASSEMBLY) SHOULDER STRAP ADJUSTMENT 1. Hold the unit as shown with the muffler side facing away from your body and clothes.
POSITION Blower Vacuum RULES BEFORE OPERATING Elbow Tube Tube Upper Blower Tube Lower Blower Tube PRIMER BUTTON The PRIMER BU_ON removes air fcom the carburetor and fuel lines and tills them with fuel. This alows you to start the engine with fewer pulls on the starter rope.
2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan PRO brand synthetic oil is recommended. Mix gasefine and oil at a refJo of 40:1. A 40:1 ratio is obtained by mixing 32...
Cleaning the air filter: 1. Clean the cover and the area around keep debds from falling into the carburetor chamber when the cover is removed NOTE: Move choke lever to RUN position before opening air fi_ter cover. 2. Open air filter cover by pushing button (see illustration)
CARBURETOR ADJUSTMENT The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions: • Engine will not idle when the throttle is re- leased. Idle Speed Adjustment Allow engine to idle. Adjust speed until engine runs without stalling (idle speed too slow).
TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performingany of the recommended remedies below other than remedies that require operation of the unit. TROUBLE CAUSE Engine will not 1. Engine flooded. start. 2. Fuel tank empty. 3. Spark g_ug not firing. 4.
As the small off-toed engine engine owner, you should be aware that Poulan PRO may deny you warranty coverage if your small off- road engine engine or a part of it has failed due to abuse, neglect, improper main-...
Page 14
ADD= ON OR MODIFIED PARTS: The use of edd-on or modified parts can be grounds for disallowing a warranty claim. Poulan PRO is not {iable to cover failures of warranted parts caused by the use of add-on or modified parts.
Need help?
Do you have a question about the BVM200VS and is the answer not in the manual?
Questions and answers