Cab Control Codes - SnowEx VX-3200 Owner's Manual

OPERATING THE SPREADER – CAB CONTROL

CAB CONTROL CODES

Code Defi nition
Cb Calibrate the Empty Hopper setting.
Cc Clear calibration data for Empty Hopper
setting; clear EH code.
LS Set LED brightness level.
SL Confi rms that LED brightness level has
been reset.
* For full instructions, see the "Setup Procedures" section.
Code Defi nition
Ar Auto-reverse sequence is active.
dU Spreader is in dump mode:
• Spinner assembly is removed.
• Back Dump buttons are enabled.
EH Empty hopper (beep will sound).
Lb Low battery. Hopper module is sensing
< 10V. (Lb becomes an error code
when module senses < 6V.)
Code Defi nition
bb Bad button.
bH Bad hopper.
CE No communication with
spreader module.
CP Spinner assembly present
fault.
Ct Control is hot.
EF Excessive drive faults.
Lit. No. 70465, Rev. 02
Setup Codes
Procedure
With control in ON mode, press and hold the left control knob until the
Cb code displays. Calibration cycle is automatic.*
Press the right control knob to clear all calibration data during the
calibration cycle.
With control in Ready mode, press and hold left control knob to get
LS code. Release pressure and turn left control knob to desired
brightness setting. Wait for confi rming SL code to display.*
Information Codes
Response
The spreader will automatically detect and attempt to clear a jam. See
the "Operating the Spreader" section of this manual.
To operate the dump function, see instructions in the "Operating the
Spreader" section of this manual.
If dU code displays when the spinner assembly harness is attached,
contact authorized dealer.
Check hopper for material.
Recalibrate Empty Hopper setting as described above for Cb code.
Refer to the Lb row under "Error Codes" (next table).
Error Codes – Spreader Operation Stopped
Possible Cause
Button is stuck.
Button was pressed while
vehicle ignition was entering
ACC or START mode.
Possible module or control
mismatch.
Loose connection.
Module lost power.
Disconnected spreader
harness while vehicle is on.
Spinner assembly harness is
not attached.
Cab temperature is too high.
Control overheated.
Too many HO and/or SO
error codes; hopper module
overheating.
18
Suggested Solution
Inspect control. Free up button.
Do not press any spreader cab control buttons
while the vehicle ignition is being engaged.
Replace control or module. Use only genuine
service parts. Contact authorized dealer.
Confi rm that spreader and control harnesses are
connected to the vehicle harness. Check power
to spreader module, all connections, fuses, and
power studs. Check that B port is plugged in.
Install the spinner assembly harness. Reset the
control by pressing the ON/OFF button.
Turn off spreader and allow control to cool off.
Control times out for 60 seconds.
Ensure the auger and/or spinner are not jammed.
Table continues on next page.
September 15, 2017