Alarm Status Display - Tektronix WFM2300 User Manual

Alarm status display

WFM2300 and WFM2200A Waveform Monitors User Manual
CONFIG menu. Use the CONFIG menu to set the following audio parameters:
■ Use the menu selections under Digital Audio Displays to configure various
audio display parameters such as meter type, ballistic characteristics, peak
program level, meter scaling, alarm thresholds, correlation speed, and turning
the Lissajous AGC mode on and off.
■ Use the menu selections under Audio Inputs/Outputs to configure audio
input and output parameters such as selecting which channels are active on
each audio input port, selecting how each audio port is displayed, selecting
the audio output source, selecting which channels to de-embed from the SDI
video, configuring the "map" of active audio for each video input, and
adjusting the speaker and headphone volume.
If Option 3G is installed, 3G Level A signals use the Embedded A or B
settings as appropriate. 3G Level B signals use the Embedded Dual Link
settings.
■ Use the menu selections under Alarms > Audio Content and Alarms >
AES/Embedded to enable various audio alarms.
The Alarm Status display shows the current status of all triggered alarms for the
currently selected video and audio inputs, and indicates whether or not they have
been enabled. Use the arrow keys to navigate through the different pages of the
display.
Figure 33: Alarm Status display
Display modes
89