Handset Settings - Pioneer CS-A50 User Manual

Handset Settings

Handset registration
1. Make sure the base unit is connected into the AC outlet and line
jack.
2. Press and hold the button on the base unit. After 3 seconds,
press the CH CODE button on the handset, the unit will give you a
confirmation beep, which means that the code has been set and the
handset will show on the LCD.
HS -1
3. If you have more than one handset, press the
the handset until you get a beep and display
same procedure, if you have the third handset. If not, release the
button from the base unit.
NOTE:
The button on the base unit should be kept pressing
during the whole procedure.
IMPORTANT NOTICE: The base unit and the handset have been set
code already.
Setting
In standby mode, press EDIT TRANS
show to indicate you enter the setting mode.
PROGRAM
Area code setting
EDIT TRANS
Press button, then
Enter the number (up to 4 digits) by keypad (you can press
AREA CODE.
R
button to delete the error digits) and press
once more to confirm. A confirmation beep will be heard.
11
CH CODE button on
. Continue the
HS -2
button once, then the LCD will
1
button, and then the LCD will show
EDIT TRANS
Caller ID Operation
Reviewing the Caller ID list
1. Press
s
numbers andnewnumbers.(
2 . Press
s
Dialling the C aller ID numbers
During the reviewing mode, press
showedonthe LCD.
If the Caller ID number exceeds 8 digits, you can dial the number as
above or in other4 ways a s follows.(e.g. thenumber is
Press 0
button
or button, the LCD shows the total number of Caller ID
t
ALL XX NEW XX )
or button to review the other caller numbers.
t
#
button to dialled out the number
JOHN BULL
button to dial the number with the
TALK
20
34567890123 )
0 digit.