Samsung IPX-G5X0 series Installation Manual page 26

SAMSUNG IPX-G5X0 Installation Manual v1.0
PRI & FXS Basic Function Checklist
The following is a quick guide to testing your
PRI functionality after your gateway is installed
and configured.
1) Prepare 2 Analog Phones and FXS / PRI cards.
a. In the SCM Administrator apply the following settings:
i. [Configuration – Gateway – IPX Setting – Gateway Configuration]
ii. [Configuration – Gateway – IPX Setting – Analog Phone]
iii. [Configuration – Trunk Routing – Route]
iv. For testing assume that your Analog Phones are PhoneA and PhoneB.
2) Check that you can set Switch Type to 5ESS5 in SCM.
3) Test calling from FXS to PRI.
a. Pick up PhoneA and dial PhoneB ([TRUNK NUMBER]+[PHONE NUMER]+#). Ex. 99
2001#
b. Ensure the call connects and has two way audio.
4) Test calling from PRI to FXS.
a. Make an incoming call with PRI assigned DID number to PhoneA.
b. Check that the PhoneA is ringing.
c. Answer and ensure the call connects and has two way audio.
5) Test that FXS ringing stops when call is terminated.
a. Pickup PhoneA and dial PhoneB.
b. Listen for the ring back tone on PhoneA and hang up. (PhoneB doesn't answer the
call.)
c. Ensure that PhoneB stops ringing after hangup.
6) Test for busy tone when making a call to a busy station.
a. Pickup the handset of PhoneB and put it down without hanging up.
b. Pickup PhoneA and dial PhoneB.
c. Check that can hear busy tone.
7) Repeat steps 2-7 while changing the Switch Mode in SCM to the following as needed:
a. 5ESS5, 5ESS9, 5ESS10, NI1, NI2, DMS100 and BELLCORE.
1. Set Country to 'USA'.
1. Assign extension numbers to the FXS card. (ex. 2001, 2002, 2003,
2004)
1. Setup a PRI TRUNK with an assigned Access Code.
Mar 2016
26