Water Inlet Screen - Frigidaire Affinity 6000 Series Service Manual

Section 4 Component Teardown
Water Inlet Valve Removal
4. Remove the (2) screws, one on each side, holding
the water inlet valve assembly to the detergent
dispenser housing. (See Figure 4-54)
5. Pull back on the valve assembly to disengage it
from the detergent dispenser housing and lift out.
(See Figure 4-55)
Screw
Figure 4-54.
Water Valve
Outlets
Figure 4-55.
4-14
Water Inlet Screen Removal
Water inlet screens are located in the ends of the water
inlet tubs to filter the incoming water. These screen
can be removed for cleaning.
To remove the water inlet screens:
1. Disconnect the incoming water hoses.
2. Each screen has a reinforced bar across the face.
Using a pliers, grab one of the legs of the bar and
pull the screen out. (See Figure 4-56)
Screens
Figure 4-56.
Top Rear Brace Removal
To remove the top rear brace:
1. Remove the top panel.
2. Using a #2 square bit screwdriver, extract the three
screws from the rear of the top rear brace.
(See Figure 4-57)
3. Extract the two screws from the top of the rear
brace and remove from unit. (See Figure 4-58)
Figure 4-57.
Figure 4-58.
Screws
Screws