Table of Contents
Advertisement
Quick Links
Glastar
of your browser window or select print from the file menu.
Super Star II™ & Diamond Star Grinders
Eye Protection
Maintenance
FOR PERSONAL SAFETY THIS MACHINE MUST BE PROPERLY GROUNDED
The power cord of this machine is equipped with a three-prong (grounding) plug which mates with a standard
three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard. Where a
standard two-prong wall receptable is encountered, it is the personal responsibility and obligation of the
customer to have it replaced with a properly grounded three-prong wall receptacle. DO NOT, UNDER ANY
CIRCUMSTANCES, CUT OR REMOVE THE THIRD (GROUNDING) PRONG FROM THE POWER CORD.
Always unplug your machine before cleaning or making any repairs-(NOTE: We strongly recommend that you return the
unit to the factory for repair.) USE ONLY IDENTICAL REPLACEMENT PARTS TO REPAIR THIS MACHINE.
OUTSIDE USA (818) 341-0301 · INSIDE USA (800) 423-5635
http://www.glastar.com/manuals/ss-ds.cfm
To print out this manual: click the PRINT icon at the top
Operation
Straight Edge Guide
DIAMOND GLASS GRINDER MANUAL
SUPER STAR II & DIAMOND STAR
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
FAX (818) 998-2078 · WEBSITE www.glastar.com
Page 1 of 5
Diamond Grinding Heads
10/24/2012
Advertisement
Table of Contents
Related Manuals for Glastar super star II
Summary of Contents for Glastar super star II
- Page 1 Page 1 of 5 To print out this manual: click the PRINT icon at the top of your browser window or select print from the file menu. Super Star II™ & Diamond Star Grinders Eye Protection Operation Diamond Grinding Heads...
- Page 2 DIAMOND GRINDING HEADS The diamond cutting surface of the head is 5/8" (15.875 mm) high. Glastar has installed the head so that the full 5/8" (15.875 mm) of diamond extends above the top plate. If all the glass you grind is 1/8" (3.175 mm) thick or less, you will only use the lower one-fifth of the cutting surface.
- Page 3 To lower the 3/4" (19.050 mm) head, loosen the set screw near the top of the head with the Allen key. The loosened head will slide up and down on the motor shaft with ease. Each time you re-position the cutting head, Glastar recommends the application of a lubricant, such as Vaseline, to the motor shaft.
- Page 4 If you have any problem with your GLASTAR GRINDER call the GLASTAR TOLL FREE NUMBER for an authorization number. Then pack the machine well and return it post-paid to GLASTAR. We will repair your grinder as rapidly as possible and return it to you post-paid.
- Page 5 Glastar Page 5 of 5 http://www.glastar.com/manuals/ss-ds.cfm 10/24/2012...
Need help?
Do you have a question about the super star II and is the answer not in the manual?
Questions and answers