Related Manuals for Silent Witness SW010.1
Summary of Contents for Silent Witness SW010.1
- Page 1 SW010.1 Silent Witness Dash Camera User Manual V2.4 November 2017 Copyright Parksafe Automotive Limited. All rights reserved. Page 1...
-
Page 2: Safety Precautions
Thank you for buying our Silent Witness Camera. This instruction manual contains information on the main functions of your Silent Witness Camera. Please read and understand these instructions prior to installing and operating this product. The contents of this manual are subject to change without user’s prior consent. - Page 3 Personal Data Protection Act and related law (statute). • Please use the authentic Silent Witness product/parts that we provide. We will not be held responsible for the breakdowns and accidents caused by the use of non-authentic Silent Witness products/parts. •...
-
Page 4: In The Event Of An Accident
SD card. • If the Silent Witness camera is being used in a commercial application. We advise the company’s fleet manager to relay this information to the drivers. We recommend keeping a spare SD memory card in the vehicle so it can be swapped in the event of an accident. - Page 5 the Product at Parksafe Automotive Limited own expense for any such defect arising after ten (10) days but within two (2) month of the original date of purchase. This Limited Warranty may not be sold – on, assigned, transferred or given to any subsequent purchaser or acquirer of the Product. 5.
- Page 6 AUTOMOTIVE LIMITED WILL NOT BE LIABLE FOR ANY LOSSES OR DAMAGES OF ANY NATURE, INCLUDING BUT NOT LIMITED TO LOST PROFITS OR COMMERCIAL LOSS OF THE CUSTOMER. 15. This Limited Warranty does not affect the Customer’s statutory rights in law specific to the country of purchase, and such - rights remain protected.
-
Page 7: Pc System Requirements
This will resolve the issue. 9. The camera will start to record automatically once the car engine is started. 10. Please set the time zone, date and time correctly before using camera. 11. The camera will not power on without an external power supply connected. 12. - Page 8 APPEARANCE 1. Bracket, double side tape stick on here. (GPS function, GPS logger is inside the bracket) 2. Micro USB port 1 3. AV port 4. Up / Menu / Mute button 5. OK button 6. Down / Playback / SOS button 7.
-
Page 9: Specification
SPECIFICATION OV2710 sensor 1.5inch TFT LCD screen Resolution: 2304*1296 30fps, 1920*1080 30fps, 1920*1080 30fps HDR, 1280*720 30fps, 1280*720 60fps IQ Image enhancement Built-in microphone / speaker Built-in super capacitor Support HDMI output Support G-sensor file protection Support SOS manual file protection Support GPS trace logging Support micro SD card up to 128GB Support parking guard (with hardwire kit, optional) -
Page 10: Operation
2. If car battery voltage falls below 11.6V, the camera will be turned off automatically. IMPORTANT Please check that this voltage is okay for your battery system on your vehicle, some vehicles may throw up errors on the instrument cluster. 3. -
Page 11: Light Indicator
Storage card preparation The camera supports micro SD card up to 128GB maximum. It is recommended to use a high speed micro MLC SD card to avoid storage problems. Please format the SD card before recording. (USE SD Formatter, Free software on www) It’s suggested to format the card every two weeks to avoid file segments which may cause recording problem. -
Page 12: Camera Menu
When camera is in standby mode, short press DOWN button, there will be a red eye on the screen, this means motion detection is on; short press DOWN button again to cancel it in standby mode. When there is no obvious motion detected the camera will switch to standby. Once motion is detected above the threshold value, the camera will start recording and continue for 30 seconds after the motion stops. - Page 13 WNR (Wind Noise Decrease) Options: OFF / ON Speed Unit Options: KMH / MPH Date Stamp Options: OFF / ON Parking Mode Options: Time lapse / OFF / Normal Auto Format Warning Every month ,on the 1st/8th/15th/22th day, when powering the camera up the first time the will give a message on the screen asking if you want to format the microSD Card.
-
Page 14: Firmware Updating
Default Setting Here you can restore all the settings to the factory default settings. Default setting in Menu, options: NO / YES Version Here you can find the current version of the firmware and batch number of your camera. You may need this information when you are trying to upgrade the camera to a later firmware. Firmware Updating Firmware update process: Important do not remove power during updating of firmware... -
Page 15: Troubleshooting
Trouble Shooting ● Cannot record video or take picture - Please check that there is enough storage space on the micro SD card. Or if you have Loop Recording on that the files are not all protected (read only attribute). Check the SD card is functioning in another device of format the SD card. -
Page 16: About The Manual
About the Manual We have tried to ensure that what is in this manual is correct and up to date. However, we can not guarantee that all content is correct without any errors. If there is a variance between the manual and camera, please accept the camera standard as correct.
Need help?
Do you have a question about the SW010.1 and is the answer not in the manual?
Questions and answers