Advanced Features (Cvs100 Or Cvs102); Integrated Active Object Detection (Radar); External Video Input / Output - Intec car vision CVD650LCD User Manual

Advanced Features

Integrated Active Object Detection (Radar)

The integrated radar, when properly connected, will send a visual alert to the Car Vision™ display and an
audible alert to the Car Vision™ remote when an object is detected within its operating range. The visual
alert consists of OSD markers on the left and right sides of the display screen. When properly connected
and powered green markers at the top of the screen will be present, indicating the radar is active. When
an object is detected in the outer most detection area, the fi rst of 5 red markers will activate starting at the
top of the screen, just under the green markers. As the object gets closer to the radar sensor(s) additional
red markers will illuminate in succession from the top of the screen to the bottom as well as start fl ashing
and an audible beeping will be heard through the remote. While in reverse, the on-screen distance grid
will also fl ash off and on according to the detected object's distance from the sensor as shown below.
The integrated radar will only operate when connected via an INTEC cable to the camera connector and
the system is triggered, via the blue wire, with a +11 to +32 VDC source.
In addition there is a source voltage 1 amp Radar Alarm output (green) wire in the controller's power
harness that can be used to activate an external device in the event your radar sensor detects an
object within it's range. ALARM must be set to ON in the installer's menu and the radar must be
detecting an object within its range before the output voltage is present. NOTE: Radar is only available
with the CVS100M and CVS100XL controllers. It is NOT available with the CVS100H.
External Video Input / Output (only available on the CVS100 series controller)
Your system is equipped with an external video input that allows you to connect another video source.
That source can be from another camera, GPS, or any other composite video source.
In addition to the video input there is also a video and audio output. These allow you to output your na-
tive* Car Vision™ camera video to an alternate display or DVR. The audio (when used with an audio
capable camera) can be output to an alternate speaker, display or DVR.
Use of the Video Input / Output requires the optional CVS100VO3M or CVS100MVO3M cable harness
available from INTEC.
* The output video is native from the camera meaning it sends video straight from the camera to the video output which in most
cases will produce a true image recording as opposed to the mirror image as seen on the display. To get a mirror image recording
you'll need to reverse the camera image as well as set the image orientation in the display to NOR.
Not all cameras are fi eld reversible and may need to be returned to INTEC to have the image reversed. Please contact INTEC for
additional information.
Page 10