Table of Contents
Advertisement
Quick Links
GRIZZLY 13' TRIPOD
Instruction and Safety Manual
MODEL: 5413D/51016
Weight Limit: 300 lbs.
Do Not Over Tighten Fasteners
THANK YOU! for purchasing Ameristep's Grizzly 13' Tripod
Warning
Every year serious injury and even death occurs from hunting related falls. To ensure your safety, please COMPLETELY read and follow this safety
manual and ALL warning labels BEFORE assembling, installing or utilizing this product.
DO NOT USE THIS PRODUCT BEFORE FULLY UNDERSTANDING ALL SAFETY WARNINGS AND INSTRUCTIONS. IF YOU HAVE QUESTIONS, ARE
UNSURE ABOUT ANY INFORMATION OR NEED ADDITIONAL INFORMATION CONCERNING YOUR PRODUCT, CONTACT OUR CUSTOMER SERVICE
DEPARTMENT AT 1-866-972-6168 OR VISIT WWW.TREESTANDCUSTOMERSERVICE.COM. KEEP AND MAINTAIN THIS SAFETY AND INSTRUCTION
MANUAL IN A SAFE LOCATION FOR FUTURE REFERENCE.
©2011 (rev 06/11)
Distributed by Primal Vantage Company Inc. 685 Route 10 East, Randolph, NJ 07869
SAFETY MUST BE YOUR FIRST PRIORITY WITH THIS PRODUCT
Advertisement
Table of Contents
Related Manuals for Ameristep GRIZZLY 51016
Summary of Contents for Ameristep GRIZZLY 51016
- Page 1 Weight Limit: 300 lbs. Do Not Over Tighten Fasteners THANK YOU! for purchasing Ameristep’s Grizzly 13’ Tripod Warning Every year serious injury and even death occurs from hunting related falls. To ensure your safety, please COMPLETELY read and follow this safety manual and ALL warning labels BEFORE assembling, installing or utilizing this product.
- Page 2 TREESTAND SAFETY WARNINGS Please read the following instruction manual and warnings labels completely before utilizing this product. Failure to understand and execute the instructions and warnings may result in serious injury or death. In the event of an accident, have a plan for rescue, including the use of devices that may be easily reached while suspended.
- Page 3 TREESTAND SAFETY WARNINGS NEVER adjust your stand while in use. Practice the attachment of this treestand at ground level before using in a hunting environment. ALWAYS ensure that you and your treestand are safely secured to a healthy tree. Your tree stand MUST be attached tightly to the tree and secured in place. If the stand is not secure, it may shift while in use, resulting in serious injury or death.
- Page 4 • Inspect for defects (damage, rot, corrosion, cracks, freezing, excessive heat, etc.) before every use is required. Do not use if damage is detected or suspected. • Ameristep recommends periodically re-tightening and/or replacing hardware (supplied by Ameristep), including bolts, nuts, washers, rope, straps, cord, etc.
- Page 5 HARDWARE AND PARTS 13’ TRIPOD Model #5413D / #51016 Upper Tripod Leg M8 x 20mm HEX BOLT Platform Shooting Rail (2 Washers, 1 Lock-Nut) Lower Shooting Rail Supports Upper Shooting Rail Supports Seat Frame Seat Back M8 x 20mm HEX BOLT (1 Washer, 1 Lock-Nut) (2) Right &...
- Page 6 P L A T F O R M A S S E M B L Y 13’ TRIPOD Model #5413D / #51016 NOTE: NOTE: You will need: M8 x 110mm HEX BOLT (2 Washers, 1 Lock-Nut) Seat Base M8 x 50mm HEX BOLT Upper Leg (2 Washers, 1 Lock-Nut) Platform...
-
Page 7: Seat Assembly
SEAT ASSEMBLY 13’ TRIPOD Model #5413D / #51016 NOTE: NOTE: You will need: Seat Back M8 x 40mm HEX BOLT M8 x 20mm HEX BOLT Seat Frame (2 Washers, 1 Lock-Nut) (1 Washer, 1 Lock-Nut) Swivel M8 x 60mm HEX BOLT (3 Washers, 1 Lock-Nut) Step 4: Bolt SWIVEL to SEAT BASE... - Page 8 SHOOTING RAIL • PLATFORM 13’ TRIPOD Model #5413D / #51016 NOTE: NOTE: You will need: Upper Legs Lower Shooting Rail Supports Seat Back Cushion Seat Cushion Shooting Rail M8 x 55mm HEX BOLT (2 Washers, 1 Lock-Nut) M8 x 40mm HEX BOLT (2 Washers, 1 Lock-Nut) Step 7: Slide SEAT and SEAT BACK CUSHION on.
- Page 9 13’ TRIPOD ASSEMBLY LEGS Model #5413D / #51016 NOTE: NOTE: You will need: Trap Door M8 x 70mm HEX BOLT (2 Washers, 1 Lock-Nut) Adjustment Knobs Step 10: Insert SHOOTING RAIL and UPPER SHOOTING RAIL SUPPORTS into LOWER SHOOTING RAIL SUPPORTS. Use (4) ADJUSTMENT KNOBS to connect both halves together.
- Page 10 ASSEMBLY LEGS CONTINUED 13’ TRIPOD Model #5413D / #51016 NOTE: NOTE: You will need: (2) Right & Left Middle Legs M8 x 50mm HEX BOLT (2 Washers, 1 Lock-Nut) LEFT RIGHT diagram 1 Step 12: Lay TRIPOD on its back as shown. Insert RIGHT and LEFT MIDDLE LEGS into BOTTOM of UPPER LEGS and secure with (4) M8 x 50mm bolts (2 bolts per leg).
- Page 11 13’ TRIPOD Model #5413D / #51016 NOTE: NOTE: You will need: Long Tripod Brace Short Tripod Brace (10) M8 x 40mm HEX BOLT Middle Ladder Leg (2 Washers, 1 Lock-Nut) Step 13: Connect MIDDLE LADDER LEG to each other with SHORT TRIPOD BRACE, secure to tabs on bottom of MIDDLE LEGS using (2) M8 x 40mm bolt.
- Page 12 13’ TRIPOD ASSEMBLY Model #5413D / #51016 NOTE: NOTE: You will need: Lower Leg Outer Ladder Brace M8 x 50mm HEX BOLT (2 Washers, 1 Lock-Nut) Lower Ladder Leg M8 x 20mm HEX BOLT (2 Washers, 1 Lock-Nut) Step 15: Insert BOTTOM LEGS into BOTTOM of MIDDLE LEG SECTIONS and BOTTOM LEG into BOTTOM of MIDDLE LEG using (6) M8 x 50mm bolts to secure them all.
- Page 13 W A R N I N G Failure to follow all warnings listed below could result in serious injury or death. DO NOT use this tripod without reading and following all NEVER use tripod during inclement weather. DO NOT use warnings and instructions before each use.
-
Page 14: Customer Service
Customer Service STOP!!! If you discover there is a missing or damaged part when you open your new product DO NOT RETURN TO STORE STOP Contact Primal Vantage’s Customer Service visit www.treestandcustomerservice.com or call 1-866-972-6168 and ask for Primal Vantage. See the parts list section of the instructions when you need to identify product and part numbers. If you are unable to identify the part number, you may email us at info@treestandcustomerservice.com. -
Page 15: Limited Warranty
Limited Warranty Warranty: Primal Vantage Company Inc., warrants that the goods described in this warranty are free from physical defects in workmanship and materials for a period of one-year from the date of purchase. Repair Procedure, exclusive Remedy: FOR BREACH OF THE EXPRESS WARRANTY ON THIS PRODUCT, THE CONSUMER IS LIMITED TO THE FOLLOWING DAMAGES: Primal Vantage Company Inc. -
Page 16: Owner's Record
You must complete and return the registration card below within thirty (30) days of the date of purchase in order to activate limited warranty coverage. Registration is also used for important product notifications. Your information will never be shared or sold to any third parties . For customer service you may do one of the following: - Visit www.treestandcustomerservice.com for replacement parts - E-mail info@treestandcustomerservice.com with comments/suggestions...
Need help?
Do you have a question about the GRIZZLY 51016 and is the answer not in the manual?
Questions and answers